# $Id: upsd.conf,v 2.0 1996/01/28 11:50:37 alexis Exp $ # # UPS Daemon # The Wild Wind Communications, 1995, 1996 # # See file LICENSE for the distribution terms of this software. # ups "smart-ups" (230) proto "apc-smart" { device "/dev/cuaa0" speed 2400 read-timeout 2 write-block-size 1 write-block-delay 50 queue-size 64 } every 5 { # check events every 5 seconds nop } on "initialize" != "SM" { poll "initialize" after 60 every 60 { log emerg "Cannot put the UPS into smart mode!" } } every 600 { tune "high-transfer-point" 264 tune "low-transfer-point" 196 tune "line-alarm" "0" tune "line-sensitivity" "L" tune "low-batteries-duration" 2 tune "nominal-voltage" 220 tune "shutdown-delay" 20 tune "wakeup-batteries-capacity" 25 tune "wakeup-delay" 0 # tune "batteries-replaced" "01/01/77" # tune "label" "WildWind" } every 300 { # poll the UPS poll "last-test" # poll "light-test" poll "line-frequency" poll "line-maxvac" poll "line-minvac" poll "line-voltage" poll "load" poll "recharge" poll "temperature" poll "vdc" poll "voltage" log notice "last test: %last-test%, light test: %light-test%" log notice "frequency: %line-frequency%, maxvac: %line-maxvac%, minvac: %line-minvac%, voltage: %line-voltage%" log notice "load: %load%, recharge: %recharge%, temp: %temperature%, vdc: %vdc%, output voltage: %voltage%" on "load" > 95 { log alert "UPS load is too high: %load%" } } on "line-fail" { log emerg "*** ALERT! Source power line failed, save your work! ***" } on "line-fail" after 30 { log emerg "*** ALERT! System shutdown in 30 seconds, LOGOUT NOW! ***" } on "line-restore" { log emerg "Source power line restored, you may continue your work." } on "line-fail" after 60 { log emerg "*** ALERT! THE SYSTEM IS SHUTTING DOWN! ***" poll "shutdown" poll "shutdown" poll "power-test" poll "power-test" poll "shutdown" poll "shutdown" sleep 2 exec "/sbin/halt &" poll "power-test" poll "shutdown" poll "power-test" poll "shutdown" poll "power-test" poll "shutdown" poll "power-test" sleep 1000 # let us wait peacefully }