Print out the length of the compiled sequencer program.
aic7xxx.seq:
More optimizations. Replace generic bcopy routine with bcopy_3
and bcopy_4 (ie unroll the loops) since these are the only two cases used.
Initialize SIMODE1 and SXFRCTL1 from the kernel in ahc_init instead of
at each selection/reselection since this is expensive and only needs to
be done once. Condense function returns into previous instruction if possible.
Reorder some sections to kill superflous jumps. These optimizations kill
the ~150k/s penalty adding support for Twin/Wide cards was costing since
the last place in the commaon path of execution where we had to do ugly,
convoluted testing for the type of card in the sequencer has gone away.
Next stop tagged queuing and target mode.
work (mi_switch() counted the last timeslice again but this didn't affect
the exiting process' rusage because the rusage has already been finalized).
Remove stale comment.
the physical device is closed. Previously only the reverse case was handled.
Abuse the cdevsw interface instead of the vfs interface to do this.
Remove unnecessary #includes.
When using cp to copy a file under the following circumstanes:
- original file in on an NFS filesystem
- destination file is on the same NFS filesystem
- the file is less than 8Mbytes in size
- the file is larger than 65536 bytes in size
the cp process can get frozen in device-wait and never wake up (cp uses
mmap() in this case).
A small change to allocbuf() fixes this.
Obtained from:
bios boot block changed to allow booting from both the attached graphics
display and from a serial port. (A specially compiled serial boot block
is no longer necessary.) The boot block should detect the presence or
absence of a keyboard: if there is no keyboard, COM1 is turned into the
console. This simulates the behavior of the Sun boot PROMs. Unplug your
keyboard, attach a terminal to COM1 and you should be ready to go. :)
Obtained from:
sio.c and sioreg.c changed to allow autodetecting the RB_SERIAL flag
passed by the boot blocks so that the kernel can switch to 'serial
console' mode automagically. 'options COMCONSOLE' can still be specified
to force the kernel to always use the serial port as a console.
CONUNIT and CONADDR can also be specified in the kernel config file
if the user wants to shift the console to a different port.
Obtained from:
Added a new flag (RB_SERIAL) which is passed by the boot block to tell
the kernel that it should use a serial port as a console. (The kernel
can still be forced to boot in serial console mode if 'options COMCONSOLE'
is used.)
Bruce Evans
Justin T. Gibbs
Garrett Wollman
Andrey A. Chernov
Bill Paul
Søren Schmidt
Jordan K. Hubbard