freebsd/sys/dev/aic7xxx/aic7770.c

/*
 * Product specific probe and attach routines for:
 * 	27/284X and aic7770 motherboard SCSI controllers
 *
 * Copyright (c) 1994, 1995, 1996, 1997, 1998, 2000 Justin T. Gibbs.
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice immediately at the beginning of the file, without modification,
 *    this list of conditions, and the following disclaimer.
 * 2. The name of the author may not be used to endorse or promote products
 *    derived from this software without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
 * ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE FOR
 * ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
 * SUCH DAMAGE.
 *
 * $Id$
 *
 * $FreeBSD$
 */

#ifdef	__linux__
#include "aic7xxx_linux.h"
#include "aic7xxx_inline.h"
#include "aic7xxx_93cx6.h"
#endif

#ifdef	__FreeBSD__
#include <dev/aic7xxx/aic7xxx_freebsd.h>
#include <dev/aic7xxx/aic7xxx_inline.h>
#include <dev/aic7xxx/aic7xxx_93cx6.h>
#endif

#define ID_AIC7770	0x04907770
#define ID_AHA_274x	0x04907771
#define ID_AHA_284xB	0x04907756 /* BIOS enabled */
#define ID_AHA_284x	0x04907757 /* BIOS disabled*/

static void aha2840_load_seeprom(struct ahc_softc *ahc);
static ahc_device_setup_t ahc_aic7770_VL_setup;
static ahc_device_setup_t ahc_aic7770_EISA_setup;;
static ahc_device_setup_t ahc_aic7770_setup;


struct aic7770_identity aic7770_ident_table [] =
{
	{
		ID_AHA_274x,
		0xFFFFFFFF,
		"Adaptec 274X SCSI adapter",
		ahc_aic7770_EISA_setup
	},
	{
		ID_AHA_284xB,
		0xFFFFFFFE,
		"Adaptec 284X SCSI adapter",
		ahc_aic7770_VL_setup
	},
	/* Generic chip probes for devices we don't know 'exactly' */
	{
		ID_AIC7770,
		0xFFFFFFFF,
		"Adaptec aic7770 SCSI adapter",
		ahc_aic7770_EISA_setup
	}
};
const int ahc_num_aic7770_devs = NUM_ELEMENTS(aic7770_ident_table);

struct aic7770_identity *
aic7770_find_device(uint32_t id)
{
	struct	aic7770_identity *entry;
	int	i;

	for (i = 0; i < ahc_num_aic7770_devs; i++) {
		entry = &aic7770_ident_table[i];
		if (entry->full_id == (id & entry->id_mask))
			return (entry);
	}
	return (NULL);
}

int
aic7770_config(struct ahc_softc *ahc, struct aic7770_identity *entry)
{
	struct	ahc_probe_config probe_config;
	int	error;
	u_int	hostconf;

	ahc_init_probe_config(&probe_config);
	error = entry->setup(ahc->dev_softc, &probe_config);
	if (error != 0)
		return (error);

	error = aic7770_map_registers(ahc);
	if (error != 0)
		return (error);

	probe_config.description = entry->name;
	error = ahc_softc_init(ahc, &probe_config);

	error = aic7770_map_int(ahc);
	if (error != 0)
		return (error);

	error = ahc_reset(ahc);
	if (error != 0)
		return (error);

	switch (probe_config.chip & (AHC_EISA|AHC_VL)) {
	case AHC_EISA:
	{
		u_int biosctrl;
		u_int scsiconf;
		u_int scsiconf1;

		biosctrl = ahc_inb(ahc, HA_274_BIOSCTRL);
		scsiconf = ahc_inb(ahc, SCSICONF);
		scsiconf1 = ahc_inb(ahc, SCSICONF + 1);

		/* Get the primary channel information */
		if ((biosctrl & CHANNEL_B_PRIMARY) != 0)
			ahc->flags |= AHC_CHANNEL_B_PRIMARY;

		if ((biosctrl & BIOSMODE) == BIOSDISABLED) {
			ahc->flags |= AHC_USEDEFAULTS;
		} else {
			if ((ahc->features & AHC_WIDE) != 0) {
				ahc->our_id = scsiconf1 & HWSCSIID;
				if (scsiconf & TERM_ENB)
					ahc->flags |= AHC_TERM_ENB_A;
			} else {
				ahc->our_id = scsiconf & HSCSIID;
				ahc->our_id_b = scsiconf1 & HSCSIID;
				if (scsiconf & TERM_ENB)
					ahc->flags |= AHC_TERM_ENB_A;
				if (scsiconf1 & TERM_ENB)
					ahc->flags |= AHC_TERM_ENB_B;
			}
		}
		/*
		 * We have no way to tell, so assume extended
		 * translation is enabled.
		 */
		ahc->flags |= AHC_EXTENDED_TRANS_A|AHC_EXTENDED_TRANS_B;
		break;
	}
	case AHC_VL:
	{
		aha2840_load_seeprom(ahc);
		break;
	}
	default:
		break;
	}

	/*
	 * Ensure autoflush is enabled
	 */
	ahc_outb(ahc, SBLKCTL, ahc_inb(ahc, SBLKCTL) & ~AUTOFLUSHDIS);

	/* Setup the FIFO threshold and the bus off time */
	hostconf = ahc_inb(ahc, HOSTCONF);
	ahc_outb(ahc, BUSSPD, hostconf & DFTHRSH);
	ahc_outb(ahc, BUSTIME, (hostconf << 2) & BOFF);

	/*
	 * Generic aic7xxx initialization.
	 */
	error = ahc_init(ahc);
	if (error != 0)
		return (error);

	/*
	 * Enable the board's BUS drivers
	 */
	ahc_outb(ahc, BCTL, ENABLE);

	return (0);
}

/*
 * Read the 284x SEEPROM.
 */
static void
aha2840_load_seeprom(struct ahc_softc *ahc)
{
	struct	  seeprom_descriptor sd;
	struct	  seeprom_config sc;
	uint16_t  checksum = 0;
	uint8_t   scsi_conf;
	int	  have_seeprom;

	sd.sd_ahc = ahc;
	sd.sd_control_offset = SEECTL_2840;
	sd.sd_status_offset = STATUS_2840;
	sd.sd_dataout_offset = STATUS_2840;		
	sd.sd_chip = C46;
	sd.sd_MS = 0;
	sd.sd_RDY = EEPROM_TF;
	sd.sd_CS = CS_2840;
	sd.sd_CK = CK_2840;
	sd.sd_DO = DO_2840;
	sd.sd_DI = DI_2840;

	if (bootverbose)
		printf("%s: Reading SEEPROM...", ahc_name(ahc));
	have_seeprom = read_seeprom(&sd,
				    (uint16_t *)&sc,
				    /*start_addr*/0,
				    sizeof(sc)/2);

	if (have_seeprom) {
		/* Check checksum */
		int i;
		int maxaddr = (sizeof(sc)/2) - 1;
		uint16_t *scarray = (uint16_t *)&sc;

		for (i = 0; i < maxaddr; i++)
			checksum = checksum + scarray[i];
		if (checksum != sc.checksum) {
			if(bootverbose)
				printf ("checksum error\n");
			have_seeprom = 0;
		} else if (bootverbose) {
			printf("done.\n");
		}
	}

	if (!have_seeprom) {
		if (bootverbose)
			printf("%s: No SEEPROM available\n", ahc_name(ahc));
		ahc->flags |= AHC_USEDEFAULTS;
	} else {
		/*
		 * Put the data we've collected down into SRAM
		 * where ahc_init will find it.
		 */
		int i;
		int max_targ = (ahc->features & AHC_WIDE) != 0 ? 16 : 8;
		uint16_t discenable;

		discenable = 0;
		for (i = 0; i < max_targ; i++){
	                uint8_t target_settings;
			target_settings = (sc.device_flags[i] & CFXFER) << 4;
			if (sc.device_flags[i] & CFSYNCH)
				target_settings |= SOFS;
			if (sc.device_flags[i] & CFWIDEB)
				target_settings |= WIDEXFER;
			if (sc.device_flags[i] & CFDISC)
				discenable |= (0x01 << i);
			ahc_outb(ahc, TARG_SCSIRATE + i, target_settings);
		}
		ahc_outb(ahc, DISC_DSB, ~(discenable & 0xff));
		ahc_outb(ahc, DISC_DSB + 1, ~((discenable >> 8) & 0xff));

		ahc->our_id = sc.brtime_id & CFSCSIID;

		scsi_conf = (ahc->our_id & 0x7);
		if (sc.adapter_control & CFSPARITY)
			scsi_conf |= ENSPCHK;
		if (sc.adapter_control & CFRESETB)
			scsi_conf |= RESET_SCSI;

		if (sc.bios_control & CF284XEXTEND)		
			ahc->flags |= AHC_EXTENDED_TRANS_A;
		/* Set SCSICONF info */
		ahc_outb(ahc, SCSICONF, scsi_conf);

		if (sc.adapter_control & CF284XSTERM)
			ahc->flags |= AHC_TERM_ENB_A;
	}
}

static int
ahc_aic7770_VL_setup(ahc_dev_softc_t dev, struct ahc_probe_config *probe_config)
{
	int error;

	error = ahc_aic7770_setup(dev, probe_config);
	probe_config->chip |= AHC_VL;
	return (error);
}

static int
ahc_aic7770_EISA_setup(ahc_dev_softc_t dev,
		       struct ahc_probe_config *probe_config)
{
	int error;

	error = ahc_aic7770_setup(dev, probe_config);
	probe_config->chip |= AHC_EISA;
	return (error);
}

static int
ahc_aic7770_setup(ahc_dev_softc_t dev, struct ahc_probe_config *probe_config)
{
	probe_config->channel = 'A';
	probe_config->channel_b = 'B';
	probe_config->chip = AHC_AIC7770;
	probe_config->features = AHC_AIC7770_FE;
	probe_config->bugs |= AHC_TMODE_WIDEODD_BUG;
	probe_config->flags |= AHC_PAGESCBS;
	return (0);
}