Attempt to initialize FreeBSD bluetooth stack while such a device is in
bootloader mode locks the adapter hardly so it requires power on/off
cycle to restore.
This change blocks ng_ubt attachment unless operational firmware is
loaded thus preventing the lock up.
Sponsored by: Future Crew LLC
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D46738
If Intel firmware is already in operational mode at boot that takes
place at warm boot, BT adaptor can generate extra HCI events which
interferes with firmware mode detection logic. Ignore them.
Sponsored by: Future Crew LLC
MFC after: 1 month
Reviewed by: bz
Differential Revision: https://reviews.freebsd.org/D46736
gcc -Wmemset-elt-size diagnosed this. The code was only initializing
the first 1/sizeof(long) bytes. On 64-bit systems, this would mean only
events up to 0x20 were initialized.
This effectively reverses the security policy for some events with
higher ids, now permitting them on unprivileged sockets. Two that are
defined are NG_HCI_EVENT_LE (0x3e) and NG_HCI_EVENT_BT_LOGO (0xfe).
PR: 280039
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D45707
ng_btsocket_hci_raw_send() wasn't verifying that the destination address
specified by sendto() is large enough to fill a struct sockaddr_hci.
Thus, when copying the socket address into an mbuf,
ng_btsocket_hci_raw_send() may read past the end of the input sockaddr
while copying.
In practice this is effectively harmless since
ng_btsocket_hci_raw_output() only uses the address to identify a
netgraph node.
Reported by: Oliver Sieber <oliver@secfault-security.com>
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Just like it was done for accept(2) in cfb1e92912, use same approach
for two simplier syscalls that return socket addresses. Although,
these two syscalls aren't performance critical, this change generalizes
some code between 3 syscalls trimming code size.
Following example of accept(2), provide VNET-aware and INVARIANT-checking
wrappers sopeeraddr() and sosockaddr() around protosw methods.
Reviewed by: tuexen
Differential Revision: https://reviews.freebsd.org/D42694
Let the accept functions provide stack memory for protocols to fill it in.
Generic code should provide sockaddr_storage, specialized code may provide
smaller structure.
While rewriting accept(2) make 'addrlen' a true in/out parameter, reporting
required length in case if provided length was insufficient. Our manual
page accept(2) and POSIX don't explicitly require that, but one can read
the text as they do. Linux also does that. Update tests accordingly.
Reviewed by: rscheff, tuexen, zlei, dchagin
Differential Revision: https://reviews.freebsd.org/D42635
The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of BSD-2-Clause.
Discussed with: pfg
MFC After: 3 days
Sponsored by: Netflix
o Assert that every protosw has pr_attach. Now this structure is
only for socket protocols declarations and nothing else.
o Merge struct pr_usrreqs into struct protosw. This was suggested
in 1996 by wollman@ (see 7b187005d1), and later reiterated
in 2006 by rwatson@ (see 6fbb9cf860).
o Make struct domain hold a variable sized array of protosw pointers.
For most protocols these pointers are initialized statically.
Those domains that may have loadable protocols have spacers. IPv4
and IPv6 have 8 spacers each (andre@ dff3237ee5).
o For inetsw and inet6sw leave a comment noting that many protosw
entries very likely are dead code.
o Refactor pf_proto_[un]register() into protosw_[un]register().
o Isolate pr_*_notsupp() methods into uipc_domain.c
Reviewed by: melifaro
Differential revision: https://reviews.freebsd.org/D36232
For some reason protosw.h is used during world complation and userland
is not aware of caddr_t, a relic from the first version of C. Broken
buildworld is good reason to get rid of yet another caddr_t in kernel.
Fixes: 886fc1e804
Now that each module handles its global and VNET initialization
itself, there is no VNET related stuff left to do in domain_init().
Differential revision: https://reviews.freebsd.org/D33541
The historical BSD network stack loop that rolls over domains and
over protocols has no advantages over more modern SYSINIT(9).
While doing the sweep, split global and per-VNET initializers.
Getting rid of pr_init allows to achieve several things:
o Get rid of ifdef's that protect against double foo_init() when
both INET and INET6 are compiled in.
o Isolate initializers statically to the module they init.
o Makes code easier to understand and maintain.
Reviewed by: melifaro
Differential revision: https://reviews.freebsd.org/D33537
isochronous transfers.
If users want to disable isochronous transfers, which cause high
frequency periodic interrupts from the USB host controller, then
net.bluetooth.usb_isoc_enable can be set to zero, either as a
sysctl(8) or as a loader.conf(5) tunable.
Differential Revision: https://reviews.freebsd.org/D33282
Submitted by: naito.yuichiro@gmail.com
PR: 238235
MFC after: 1 week
Sponsored by: NVIDIA Networking
Like other Intel controllers, these require firmware to be loaded, and
generic ng_ubt attach causes them to lock up until a power cycle.
However, their firmware interface for querying version info and loading
operational firmware is different from that implemented by ng_ubt_intel
and iwmbtfw, so they are not usable yet. Just disable attach for now to
avoid stalls during USB device enumeration.
PR: 260161
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
The ng_h4 module was disconnected 13 years ago when the tty later was
locked by Ed. It completely fails to compile, and has a number of false
positives for Giant use. Remove it for lack of interest. Bluetooth has
largely (completely?) moved on from bluetooth over UART transport.
OK'd by: emax
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D31846
ng_uncallout. Most of them do not check it anyway, so very little node
changes are required.
Reviewed by: mjg, markj
Differential Revision: https://reviews.freebsd.org/D31476
Currently, most protocols implement pru_listen with something like the
following:
SOCK_LOCK(so);
error = solisten_proto_check(so);
if (error) {
SOCK_UNLOCK(so);
return (error);
}
solisten_proto(so);
SOCK_UNLOCK(so);
solisten_proto_check() fails if the socket is connected or connecting.
However, the socket lock is not used during I/O, so this pattern is
racy.
The change modifies solisten_proto_check() to additionally acquire
socket buffer locks, and the calling thread holds them until
solisten_proto() or solisten_proto_abort() is called. Now that the
socket buffer locks are preserved across a listen(2), this change allows
socket I/O paths to properly interlock with listen(2).
This fixes a large number of syzbot reports, only one is listed below
and the rest will be dup'ed to it.
Reported by: syzbot+9fece8a63c0e27273821@syzkaller.appspotmail.com
Reviewed by: tuexen, gallatin
MFC after: 1 month
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D31659
SO_RERROR indicates that receive buffer overflows should be handled as
errors. Historically receive buffer overflows have been ignored and
programs could not tell if they missed messages or messages had been
truncated because of overflows. Since programs historically do not
expect to get receive overflow errors, this behavior is not the
default.
This is really really important for programs that use route(4) to keep
in sync with the system. If we loose a message then we need to reload
the full system state, otherwise the behaviour from that point is
undefined and can lead to chasing bogus bug reports.
Reviewed by: philip (network), kbowling (transport), gbe (manpages)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D26652
Some code was using it already, but in many places we were testing
SO_ACCEPTCONN directly. As a small step towards fixing some bugs
involving synchronization with listen(2), make the kernel consistently
use SOLISTENING(). No functional change intended.
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
As this controller requires firmware patch downloading to operate.
"Intel Wireless 7265" support in iwmbtfw(8) is yet to be done.
Tested by: arrowd et al
PR: 228787
MFC after: 2 weeks
Unconditional execution of "clear feature" request at SETUP stage was
workaround for probe failures on ng_ubt.ko re-kldloading which is
unnecessary now.
Reviewed by: hselasky
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D29775
Historically receive buffer overflows have been ignored and programs
could not tell if they missed messages or messages had been truncated
because of overflows. Since programs historically do not expect to get
receive overflow errors, this behavior is not the default.
This is really really important for programs that use route(4) to keep in sync
with the system. If we loose a message then we need to reload the full system
state, otherwise the behaviour from that point is undefined and can lead
to chasing bogus bug reports.
pccard is being removed, so remove bt3c driver since it only has PC
Card attachment. Also remove bt3cfw(8) since it's the firmware for this
driver.
Relnotes: Yes
ACL packet boundary flag should be 0 instead of 2 for LE PDU.
Some HCI will drop LE packet with PB flag is 2, and if sent,
some target may reject the packet.
PR: 248024
Reported by: Greg V
Reviewed by: Greg V, emax
Differential Revision: https://reviews.freebsd.org/D25704
