in rev. 1.40 of ufs_inode.c, which allows an inode being truncated
even when the filesystem itself is marked RDONLY. A subsequent
call of UFS_TRUNCATE (ffs_truncate) would panic the system as it
asserts that it can only be called when the filesystem is mounted
read-write (same changeset, rev. 1.74 of sys/ufs/ffs/ffs_inode.c).
Because ffs_mount() already takes care of sync'ing the filesystem
to disk before being downgraded to readonly, it appears to be more
desirable that we should not permit this sort of writes to disk.
This change would fix a panic that occours when read-only mounted
a corrupted filesystem and doing some file operations.
MT6/5/4 candidate
Reviewed by: mckusick
It confuses the lock manager since in some places thread0 is
then used for vnode locking while curthread is used for vnode unlocking.
Found by: Yahoo!
Reviewed by: ps@,jhb@
MFC after: 3 days
(not in mdoc(7) sense yet) in ifconfig(8) manpage, create such
subsections for gif(4) and vlan(4) so that their specific
options are not mixed up with general options.
underlying the POSIX fifo implementation. In 6.x/7.x, fifo access is
moved from the VFS layer, where it was serialized using the vnode
lock, to the file descriptor layer, where access is protected by a
reference count but not serialized. This exposed socket buffer
locking to high levels of parallelism in specific fifo workloads, such
as make -j 32, which expose as yet unresolved socket buffer bugs.
fi_sx re-adds serialization about the read and write routines,
although not paths that simply test socket buffer mbuf queue state,
such as the poll and kqueue methods. This restores the extra locking
cost previously present in some cases, but is an effective workaround
for the instability that has been experienced. This workaround should
be removed once the bug in socket buffer handling has been fixed.
Reported by: kris, jhb, Julien Gabel <jpeg at thilelli dot net>,
Peter Holm <peter at holm dot cc>, others
MFC after: 3 days
chips where setting the FAILDIS bit is not effective. While here,
try again to make it clear that reported parity errors indicate
a failure of some PCI device *other than* the aic7xxx controller.
timer reset rather than the timer of an SCB still pending on the
controller after recovery completed. This should correct timeout
loops seen in the field.
so. If the full list of fe(4) options is documented we can revive the
entire section.
PR: docs/86228
Submitted by: n-kogane@syd.odn.ne.jp
Helped by: Masahiro Sekiguchi <seki@jp.fujitsu.com>
MFC after: 1 week
copied mbuf, which keeps the IP header 32-bit aligned. This copied mbuf is
reinjected back into ether_input and off to the IP routines.
Reported and tested by: Peter van Dijk
Approved by: mlaier (mentor)
MFC after: 3 days
a thread holding critical resource, e.g mutex or other implicit
synchronous flags. Give thread which exceeds nice threshold a minimum
time slice.
PR: kern/86087
has been removed. It has been replaced by hw.pci.do_power_nodriver
and hw.pci.do_power_resume. The former defaults to 0 while the latter
defaults to 1.
When do_powerstate was set to 0, it broke suspend/resume for a lot of
people as an unintended consequence. This change will only affect the
areas that were intended to affect. This change will have no effect on
servers, but will help laptops quite a bit.
MFC After: 3 days.
