systems that are automounted, since that configuration
isn't supported. This still allows the export, since
two emails I received felt that this should not be
disabled. It sends the message to syslog(LOG_ERR..), so that
it goes to the same places as the other messages related
to /etc/exports problems, even though it is a warning and not an error.
Reviewed by: trasz
MFC after: 2 weeks
The driver uses ifm_data to save capabilities mask calculated during
initialization when supported phy modes are discovered.
The patch simply calculates it when either media or options are changed.
Reviewed by: glebius
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2540
Without these CFLAGS settings a cross-compile won't find the headers
anywhere.
Tested:
* mips (32, big endian) cross-build w/ LOCAL_DIRS including these
tools.
It is required for the next patch which adds dependency of TSO
capabilities from Tx checksum offloads.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2553
* simplify channel logic for determining RF gain setting in scan setup
* don't set TX timer on error
* free node references for unsent frames on device stop
* set maxfrags to IWN_MAX_SCATTER-1 (first segment is used by TX command)
* add missing IWN_UNLOCK() from interrupt path when the hardware
disappears.
* pass control frames to host
* nitems() instead of local macro
Tested:
* Intel 5100, STA mode
PR: kern/196264
Submitted by: Andriy Voskoboinyk <s3erios@gmail.com>
It is a preparation to the next patch which will service packet queue even
if packet addtion fails.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2552
Now each branch has one and only one possible TxQ lock state.
It simplifies understanding of the code.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2551
We can't disable it in HW, but we can ignore result.
Discard Rx descriptor checksum flags if Rx checksum offload is off.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2544
previous releases.
Also add a stdlib.h wrapper, which declares the function, otherwise the
compiler may assume it returns int, which can cause segfaults on LP64
architectures.
Reviewed by: bapt
Differential Revision: https://reviews.freebsd.org/D2558
This lets the compiler know about the alignment of pointers returned
by aligned_alloc(3), posix_memalign(3). and contigmalloc(9)
Currently this is only supported in recent gcc but we are ready to
use it if clang implements it.
Relnotes: yes
In general it is bad practice to use the gnu_inline attribute but we
will need it in special cases like FORTIFY_SOURCE. In this specific
case it is also useful to have the "artificial" attribute:
"This attribute is useful for small inline wrappers which if possible
should appear during debugging as a unit, depending on the debug info
format it will either mean marking the function as artificial or using the
caller location for all instructions within the inlined body."
This attribute appears to be currently implemented only in GCC. Use it
only in conjuntion with gnu_inline in the cases where it is available,
which is similar in spirit in how it's used in glibc.
The Alpine Platform-On-Chip offers multicore processing
(quad ARM Cortex-A15), 1/10Gb Ethernet, SATA 3, PCI-E 3,
DMA engines, Virtualization, Advanced Power Management and other.
This code drop involves basic platform support including:
SMP, IRQs, SerDes, SATA. As of now it is missing the PCIe support.
Part of the functionality is provided by the low-level code (HAL)
delivered by the chip vendor (Annapurna Labs) and is a subject to
change in the future (is planned to be moved to sys/contrib directory).
The review log for this commit is available here:
https://reviews.freebsd.org/D2340
Reviewed by: andrew, ian, imp
Obtained from: Semihalf
Sponsored by: Annapurna Labs
Perform cache writebacks and invalidations in the correct (inner to outer
or vice versa) order, and add comments that explain that.
Consistantly use 'va' as the variable name for virtual addresses.
Submitted by: Michal Meloun <meloun@miracle.cz>
was granted via rings and ni_bufs_list_head represented in those rings
and lists (e.g., via SIGKILL), those buffers are no longer available
for subsequent users for the lifetime of the system. To mitigate this
resource leak, reset the allocator state when the last ref to that
allocator is released.
Note that this only recovers leaked resources for an allocator when
there are no longer any users of that allocator, so there remain
circumstances in which leaked allocator resources may not ever be
recovered - consider a set of multiple netmap processes that are all
using the same allocator (say, the global allocator) where members of
that set may be killed and restarted over time but at any given point
there is one member of that set running.
Based on intial work by adrian@.
Reviewed by: Giuseppe Lettieri (g.lettieri@iet.unipi.it), luigi
Approved by: jmallett (mentor)
MFC after: 1 week
Sponsored by: Norse Corp, Inc.
Clang's OpenMP support will emit Intel OpenMP API library calls,
and will therefore require libiomp (or whatever name is settled on).
An up-to-date version of libgomp is included in ports or pkg GCC.
Thus, there is no reason to build base libgomp without base system GCC.
PR: 199979 (exp-run)
Reviewed by: pfg
Relnotes: Yes
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D2459
thread awakened due to a time out, then cv_waiters was not decremented.
If INT_MAX threads timed out on a cv without an intervening cv_broadcast,
then cv_waiters could overflow. To fix this, have each sleeping thread
decrement cv_waiters when it resumes.
Note that previously cv_waiters was protected by the sleepq chain lock.
However, that lock is not held when threads resume from sleep. In
addition, the interlock is also not always reacquired after resuming
(cv_wait_unlock), nor is it always held by callers of cv_signal() or
cv_broadcast(). Instead, use atomic ops to update cv_waiters. Since
the sleepq chain lock is still held on every increment, it should
still be safe to compare cv_waiters against zero while holding the
lock in the wakeup routines as the only way the race should be lost
would result in extra calls to sleepq_signal() or sleepq_broadcast().
Differential Revision: https://reviews.freebsd.org/D2427
Reviewed by: benno
Reported by: benno (wrap of cv_waiters in the field)
MFC after: 2 weeks
gif(4) interface. Add new option "ignore_source" for gif(4) interface.
When it is enabled, gif's encapcheck function requires match only for
packet's destination address.
Differential Revision: https://reviews.freebsd.org/D2004
Obtained from: Yandex LLC
MFC after: 2 weeks
Sponsored by: Yandex LLC
to handle per-thread information. Since our pthread_setspecific()
implementation calls calloc(3) to allocate per-thread specific data
storage, things get complicated.
Switch the allocator to use bare mmap(2). There is some loss of the
allocated page, since e.g. on amd64, PTHREAD_KEYS_MAX * sizeof(struct
pthread_specific_elem) is 3K (it actually spans whole page due to
padding), but I believe it is more acceptable than additional code for
specialized allocator().
The alternatives would either to make the specific data array be part of
the struct thread, or use internal bindings to call the libc malloc,
avoiding interposing.
Also do the style pass over the thr_spec.c, esp. simplify the
conditionals nesting by returning early when an error detected.
Remove trivial comments.
Found by: yuri@rawbw.com
PR: 200138
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
particular, switch to the proc0 pmap to have expected %cr3 and PCID
for the thread0 during initialization, and the up to date pm_active
mask.
pmap_pinit0() should be done after proc0->p_vmspace is assigned so
that the amd64 pmap_activate() find the correct curproc pmap.
Sponsored by: The FreeBSD Foundation
MFC after: 3 weeks
suspended thread itself, on the return path from
thread_suspend_check(). A consequence is that return from
thread_single_end(SINGLE_BOUNDARY) may leave p_boundary_count
non-zero, it might be even equal to the threads count.
Now, assume that we have two threads in the process, both calling
execve(2). Suppose that the first thread won the race to be the
suspension thread, and that afterward its exec failed for any reason.
After the first thread did thread_single_end(SINGLE_BOUNDARY), second
thread becomes the process suspension thread and checks
p_boundary_count. The non-zero value of the count allows the
suspension loop to finish without actually suspending some threads.
In other words, we enter exec code with some threads not suspended.
Fix this by decrementing p_boundary_count in the
thread_single_end()->thread_unsuspend_one() during marking the thread
as runnable. This way, a return from thread_single_end() guarantees
that the counter is cleared. We do not care whether the unsuspended
thread has a chance to run.
Add some asserts to ensure the state of the process when single
boundary suspension is lifted. Also make thread_unuspend_one()
static.
In collaboration with: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
It simplifies understanding of the sfxge_tx_packet_add() logic and
avoids passing of 'locked' to called function.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2547
It is simply not required since the kernel checks corresponding
IFCAP_TSOx capability and CSUM_TSO in hw-assisted offloads.
Note that CSUM_TSO is two bits (CSUM_IP_TSO|CSUM_IP6_TSO) and both bits
are set in IPv4 and IPv6 mbufs.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2546
Also it is cheaper to check Rx descriptor flags than TCP protocol in IP
header.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2542
For consistency with the naming conventions used by the other
implementations kill armv7_sleep and keep armv7_cpu_sleep.
Differential Revision: https://reviews.freebsd.org/D2537
Submitted by: John Wehle
Reviewed by: ian@, andrew@
Set a proper error message if we hit end-of-file when
trying to read a cpio header.
Suggested by Issue #395, although the actual problem there
seems to have been the same as Issue #394.
Add a check to archive_read_filter_consume to reject any
attempts to move the file pointer by a negative amount.
Note: Either this or commit 3865cf2 provides a fix for
Issue 394.
Issue 394: Segfault when reading malformed old-style cpio archives
Root cause here was an implicit cast that resulted in
reading very large file sizes as negative numbers.
The Windows virtio driver ignores the advertized seg_max
field and assumes the host can accept up to 67 segments
in indirect descriptors, triggering an assert in the bhyve
process.
No objection from: mav
Reviewed by: neel
Reported and tested by: Leon Dang (ldang@nahannisys.com)
MFC after: 2 weeks
