Broke locking on named pipes in the same way as locking on non-vnodes
(wrong errno). This will be fixed later.
The fix involves negative logic. Named pipes are now distinguished from
other types of files with vnodes, and there is additional code to handle
vnodes and named pipes in the same way only where that makes sense (not
for lseek, locking or TIOCSCTTY).
fcntl() and EOPNOTSUPP for flock(). POSIX specifies the weaker EINVAL
errno and the man page agrees.
Not fixed:
deadfs: always returns wrong EBADF
devfs, msdosfs: always return sometimes-wrong EINVAL
cd9660, fdesc, kernfs, portal: always return sometimes-wrong EOPNOTSUPP
procfs: always returns wrong EIO
mfs: panic?!
nfs: fudged
NetBSD uses a generic file system genfs to do return the sometimes-wrong
EOPNOTSUPP more consistently :-)(.
Found by: NIST-PCTS
- C++ should be supported for application functions (use __BEGIN_DECLS,
etc.).
- prototypes should be sorted.
- comments on #endif's should spell identifiers the same as the code.
- comments on #endif's should have the same sense as the code (use `!'
to match ifndef, etc.).
> wollman 96/12/10 09:19:15
>
> Modified: lib/libc/net ether_addr.c ethers.3
> Log:
> Get struct ether_addr directly from <net/ethernet.h> rather than pulling
> in lots of unrelated junk from <net/if.h> and <net/if_ether.h>. These
> functions still aren't prototyped anywhere (but should be in
> <net/ethernet.h>---got that, Bill?).
(Note that this file has no copyright header; one should probably
be added.)
This makes unexpected faults (in an interrupt handler) more likely
to crash properly. It could be done even better (more robustly and
more efficiently) using lazy fault handling.
They were garbage that happened to be 0 in many cases. (real_to_prot()
happens to leave the value of the real-mode %cr0 in %eax and the
memory-size BIOS calls usually don't touch the upper bits of %eax.
The upper 16 bits of %cr0 are usually 0 at boot time, at least on
486's.
Should be in 2.2.
configure() where it always belonged. It was originally slightly
misplaced after configure(). Rev.138 left it completely misplaced
before the DEVFS, DRIVERS and CONFIGURE sysinits by not moving it
together with configure().
Restored the printing of bootinfo.bi_n_bios_used now that it can
be nonzero.
was found, or if there was a checksum mismatch.
This patch should allow the driver to be used with any AMD 53c974
based SCSI card, or with the AMD SCSI+Ethernet Combo Chip found on
some motherboards.
Use the interface MTU instead of the constant when deciding what
packets to accept.
Allow using the SIOCSIFMTU ioctl (e.g. "ifconfig tun0 mtu XXX") to
set the MTU.
