with the FIN bit set for all segments, if a FIN has already been sent before.
The fix will allow the FIN bit to be set for only the last segment, in case
it has to be retransmitted.
Fix another bug that would have caused snd_nxt to be pulled by len if
there was an error from ip_output. snd_nxt should not be touched
during sack retransmissions.
1) data to be sent to the right of snd_recover.
2) send more data then whats in the send buffer.
The fix is to postpone sack retransmit to a subsequent recovery episode
if the current retransmit pointer is beyond snd_recover.
Thanks to Mohan Srinivasan for helping fix the bug.
Submitted by:Daniel Lang
originated on RELENG_4 and was ported to -CURRENT.
The scoreboarding code was obtained from OpenBSD, and many
of the remaining changes were inspired by OpenBSD, but not
taken directly from there.
You can enable/disable sack using net.inet.tcp.do_sack. You can
also limit the number of sack holes that all senders can have in
the scoreboard with net.inet.tcp.sackhole_limit.
Reviewed by: gnn
Obtained from: Yahoo! (Mohan Srinivasan, Jayanth Vijayaraghavan)
encapsulated within an IPv6 datagram, do not abuse the 'ipov' pointer
when registering trace records. 'ipov' is specific to IPv4, and
will therefore be uninitialized.
[This fandango is only necessary in the first place because of our
host-byte-order IP field pessimization.]
PR: kern/60856
Submitted by: Galois Zheng
unless the segment really contains the last of the data for the stream.
PR: kern/34619
Obtained from: OpenBSD (tcp_output.c rev 1.47)
Noticed by: Joseph Ishac
Reviewed by: George Neville-Neil
labeling new mbufs created from sockets/inpcbs in IPv4. This helps avoid
the need for socket layer locking in the lower level network paths
where inpcb locks are already frequently held where needed. In
particular:
- Use the inpcb for label instead of socket in raw_append().
- Use the inpcb for label instead of socket in tcp_output().
- Use the inpcb for label instead of socket in tcp_respond().
- Use the inpcb for label instead of socket in tcp_twrespond().
- Use the inpcb for label instead of socket in syncache_respond().
While here, modify tcp_respond() to avoid assigning NULL to a stack
variable and centralize assertions about the inpcb when inp is
assigned.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, McAfee Research
This is the first of two commits; bringing in the kernel support first.
This can be enabled by compiling a kernel with options TCP_SIGNATURE
and FAST_IPSEC.
For the uninitiated, this is a TCP option which provides for a means of
authenticating TCP sessions which came into being before IPSEC. It is
still relevant today, however, as it is used by many commercial router
vendors, particularly with BGP, and as such has become a requirement for
interconnect at many major Internet points of presence.
Several parts of the TCP and IP headers, including the segment payload,
are digested with MD5, including a shared secret. The PF_KEY interface
is used to manage the secrets using security associations in the SADB.
There is a limitation here in that as there is no way to map a TCP flow
per-port back to an SPI without polluting tcpcb or using the SPD; the
code to do the latter is unstable at this time. Therefore this code only
supports per-host keying granularity.
Whilst FAST_IPSEC is mutually exclusive with KAME IPSEC (and thus IPv6),
TCP_SIGNATURE applies only to IPv4. For the vast majority of prospective
users of this feature, this will not pose any problem.
This implementation is output-only; that is, the option is honoured when
responding to a host initiating a TCP session, but no effort is made
[yet] to authenticate inbound traffic. This is, however, sufficient to
interwork with Cisco equipment.
Tested with a Cisco 2501 running IOS 12.0(27), and Quagga 0.96.4 with
local patches. Patches for tcpdump to validate TCP-MD5 sessions are also
available from me upon request.
Sponsored by: sentex.net
recwin and sendwin. This removes a big source of confusion and makes
following the code much easier.
Reviewed by: sam (mentor)
Obtained from: DragonFlyBSD rev 1.6 (hsu)
the routing table. Move all usage and references in the tcp stack
from the routing table metrics to the tcp hostcache.
It caches measured parameters of past tcp sessions to provide better
initial start values for following connections from or to the same
source or destination. Depending on the network parameters to/from
the remote host this can lead to significant speedups for new tcp
connections after the first one because they inherit and shortcut
the learning curve.
tcp_hostcache is designed for multiple concurrent access in SMP
environments with high contention and is hash indexed by remote
ip address.
It removes significant locking requirements from the tcp stack with
regard to the routing table.
Reviewed by: sam (mentor), bms
Reviewed by: -net, -current, core@kame.net (IPv6 parts)
Approved by: re (scottl)
- share policy-on-socket for listening socket.
- don't copy policy-on-socket at all. secpolicy no longer contain
spidx, which saves a lot of memory.
- deep-copy pcb policy if it is an ipsec policy. assign ID field to
all SPD entries. make it possible for racoon to grab SPD entry on
pcb.
- fixed the order of searching SA table for packets.
- fixed to get a security association header. a mode is always needed
to compare them.
- fixed that the incorrect time was set to
sadb_comb_{hard|soft}_usetime.
- disallow port spec for tunnel mode policy (as we don't reassemble).
- an user can define a policy-id.
- clear enc/auth key before freeing.
- fixed that the kernel crashed when key_spdacquire() was called
because key_spdacquire() had been implemented imcopletely.
- preparation for 64bit sequence number.
- maintain ordered list of SA, based on SA id.
- cleanup secasvar management; refcnt is key.c responsibility;
alloc/free is keydb.c responsibility.
- cleanup, avoid double-loop.
- use hash for spi-based lookup.
- mark persistent SP "persistent".
XXX in theory refcnt should do the right thing, however, we have
"spdflush" which would touch all SPs. another solution would be to
de-register persistent SPs from sptree.
- u_short -> u_int16_t
- reduce kernel stack usage by auto variable secasindex.
- clarify function name confusion. ipsec_*_policy ->
ipsec_*_pcbpolicy.
- avoid variable name confusion.
(struct inpcbpolicy *)pcb_sp, spp (struct secpolicy **), sp (struct
secpolicy *)
- count number of ipsec encapsulations on ipsec4_output, so that we
can tell ip_output() how to handle the packet further.
- When the value of the ul_proto is ICMP or ICMPV6, the port field in
"src" of the spidx specifies ICMP type, and the port field in "dst"
of the spidx specifies ICMP code.
- avoid from applying IPsec transport mode to the packets when the
kernel forwards the packets.
Tested by: nork
Obtained from: KAME
code has rotten a bit so that the header length is not correct at
the point when tcp_trace is called. Temporarily compute the correct
value before the call and restore the old value after. This makes
ports/benchmarks/dbs to almost work.
This is a NOP unless you compile with TCPDEBUG.
routine does not require a tcpcb to operate. Since we no longer keep
template mbufs around, move pseudo checksum out of this routine, and
merge it with the length update.
Sponsored by: DARPA, NAI Labs
- delay acks for T/TCP regardless of delack setting
- fix bug where a single pass through tcp_input might not delay acks
- use callout_active() instead of callout_pending()
Sponsored by: DARPA, NAI Labs
configuration stuff as well as conditional code in the IPv4 and IPv6
areas. Everything is conditional on FAST_IPSEC which is mutually
exclusive with IPSEC (KAME IPsec implmentation).
As noted previously, don't use FAST_IPSEC with INET6 at the moment.
Reviewed by: KAME, rwatson
Approved by: silence
Supported by: Vernier Networks
o instead of a list of mbufs use a list of m_tag structures a la openbsd
o for netgraph et. al. extend the stock openbsd m_tag to include a 32-bit
ABI/module number cookie
o for openbsd compatibility define a well-known cookie MTAG_ABI_COMPAT and
use this in defining openbsd-compatible m_tag_find and m_tag_get routines
o rewrite KAME use of aux mbufs in terms of packet tags
o eliminate the most heavily used aux mbufs by adding an additional struct
inpcb parameter to ip_output and ip6_output to allow the IPsec code to
locate the security policy to apply to outbound packets
o bump __FreeBSD_version so code can be conditionalized
o fixup ipfilter's call to ip_output based on __FreeBSD_version
Reviewed by: julian, luigi (silent), -arch, -net, darren
Approved by: julian, silence from everyone else
Obtained from: openbsd (mostly)
MFC after: 1 month
not meant to duplicate) TCP/Vegas. Add four sysctls and default the
implementation to 'off'.
net.inet.tcp.inflight_enable enable algorithm (defaults to 0=off)
net.inet.tcp.inflight_debug debugging (defaults to 1=on)
net.inet.tcp.inflight_min minimum window limit
net.inet.tcp.inflight_max maximum window limit
MFC after: 1 week
kernel access control.
Instrument the TCP socket code for packet generation and delivery:
label outgoing mbufs with the label of the socket, and check socket and
mbuf labels before permitting delivery to a socket. Assign labels
to newly accepted connections when the syncache/cookie code has done
its business. Also set peer labels as convenient. Currently,
MAC policies cannot influence the PCB matching algorithm, so cannot
implement polyinstantiation. Note that there is at least one case
where a PCB is not available due to the TCP packet not being associated
with any socket, so we don't label in that case, but need to handle
it in a special manner.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
Ensure that the syn cache's syn-ack packets contain the same
ip_tos, ip_ttl, and DF bits as all other tcp packets.
PR: 39141
MFC after: 2 weeks
This time, make sure that ipv4 specific code (aka all of the above)
is only run in the ipv4 case.
o Add a mutex (sb_mtx) to struct sockbuf. This protects the data in a
socket buffer. The mutex in the receive buffer also protects the data
in struct socket.
o Determine the lock strategy for each members in struct socket.
o Lock down the following members:
- so_count
- so_options
- so_linger
- so_state
o Remove *_locked() socket APIs. Make the following socket APIs
touching the members above now require a locked socket:
- sodisconnect()
- soisconnected()
- soisconnecting()
- soisdisconnected()
- soisdisconnecting()
- sofree()
- soref()
- sorele()
- sorwakeup()
- sotryfree()
- sowakeup()
- sowwakeup()
Reviewed by: alfred
Now that we've increased the size of our send / receive buffers, bursting
an entire window onto the network may cause congestion. As a result,
we will slow start beginning with a flightsize of 4 packets.
Problem reported by: Thomas Zenker <thz@Lennartz-electronic.de>
MFC after: 3 days
receiver was not sending an immediate ack with delayed acks turned on
when the input buffer is drained, preventing the transmitter from
restarting immediately.
Propogate the TCP_NODELAY option to accept()ed sockets. (Helps tbench and
is a good idea anyway).
Some cleanup. Identify additonal issues in comments.
MFC after: 1 day
to send all its data, especially when the data is less than one MSS.
This fixes an issue where the stack was delaying the sending
of data, eventhough there was enough window to send all the data and
the sending of data was emptying the socket buffer.
Problem found by Yoshihiro Tsuchiya (tsuchiya@flab.fujitsu.co.jp)
Submitted by: Jayanth Vijayaraghavan
connection. The information contained in a tcptemp can be
reconstructed from a tcpcb when needed.
Previously, tcp templates required the allocation of one
mbuf per connection. On large systems, this change should
free up a large number of mbufs.
Reviewed by: bmilekic, jlemon, ru
MFC after: 2 weeks
This work was based on kame-20010528-freebsd43-snap.tgz and some
critical problem after the snap was out were fixed.
There are many many changes since last KAME merge.
TODO:
- The definitions of SADB_* in sys/net/pfkeyv2.h are still different
from RFC2407/IANA assignment because of binary compatibility
issue. It should be fixed under 5-CURRENT.
- ip6po_m member of struct ip6_pktopts is no longer used. But, it
is still there because of binary compatibility issue. It should
be removed under 5-CURRENT.
Reviewed by: itojun
Obtained from: KAME
MFC after: 3 weeks
other "system" header files.
Also help the deprecation of lockmgr.h by making it a sub-include of
sys/lock.h and removing sys/lockmgr.h form kernel .c files.
Sort sys/*.h includes where possible in affected files.
OK'ed by: bde (with reservations)
