- Do not mark CSUM_IP_CHECKED and CSUM_IP_VALID on IPv6 packets.
IPv6 does not have checksums by definition.
- Set SCTP packets csum_flags CSUM_SCTP_VALID instead of
CSUM_DATA_VALID and skip csum_data
- Set csum_data simply as 0xffff without byteswap
Pointed out by: yongari
Reviewed by: yongari, wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5537
It is not necessary as entries are being manipulated under lock.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5536
TSO packets will signal segments TX completion in the separate CQ
descriptors. Each CQ descriptor for HW TSO will point to the same
SQ entry.
Do not invoke nicvf_put_sq_desc() for secondary segments to avoid
free_cnt corruption and eventually integer overflow that will result
in the negative free_cnt value and hence impossibility of further
transmission.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5535
Do not modify NIC_QSET_CQ_0_7_HEAD manually, especially
in non-atomic context.
It doesn't seem to be necessary to recreate CQ head after
interrupt clearing too.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5533
On Pass2.0 can trigger interrupt on both timer and CQ count.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5423
This is not needed and causes revid register of the PCI
configuration space to clear on Pass2.0.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5421
Don't postpone Tx if the Tx lock can be acquired now.
This gives 3x better performance on egress.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5325
VNIC manages counters in hardware hence it is desired to have this
option enabled to avoid redundant stats update in ether_input_internal().
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5323
Support for software LRO when enabled in the capabilities
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5321
- The network controller verifies Rx TCP/UDP/SCTP checksums by default.
Communicate this to the stack when the packet is not marked as erroneous
to avoid redundant checksum calculation in kernel.
- It is not uncommon to get the mbuf with m_len that is less than
the minimal size for the IP, TCP, UDP, etc. when HW checsumming
is enabled. To avoid data corruption performed by the HW that is
intended to write IP and TCP/UDP/SCTP checksums to the data segment,
the mbuf needs to be pulled up by the required number of bytes.
- Make sure that one can modify the mbufs that require checsum calculation
rather than check for NULL mbuf on each transmission.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5320
This simplifies checking for default resource range for bus_alloc_resource(),
and improves readability.
This is part of, and related to, the migration of rman_res_t from u_long to
uintmax_t.
Discussed with: jhb
Suggested by: marcel
ofw_bus_get_node() must be tested against negative values since
missing parent bus method will result in calling the default method
which simply returns (-1): sys/dev/ofw/ofw_bus_if.m
This was lost in the review process.
Obtained from: Semihalf
Sponsored by: Cavium
Some firmware revisions provide different DTB tree that include
odd MDIO placement in the tree.
This commit adds support for 2 new buses:
- MRML bridge (PCIB subordinate)
- MDIO nexus (MRML subordinate)
This allows for the correct MDIO attachment with both - new and old
firmware.
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5070
Search for BGX node in DTS in two ways:
1. Try to find it uder root node first
2. If not found under root, find the top level PCI bridge node
and search all nodes below it until appropriate BGX node is found.
Move search code to another function to make the code more clear.
Remove unused variable by the way.
Reviewed by: wma
Obtained from: Semihalf
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D5066
This commit adds support for MDIO present in the ThunderX SoC.
From the FDT point of view it is compatible with "octeon-3860-mdio"
however only C22 mode is used.
The code also implements lmac_if interface functions.
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
- The driver consists of three main componens: PF, VF, BGX
- Requires appropriate entries in DTS and MDIO driver
- Supports only FDT configuration
- Multiple Tx queues and single Rx queue supported
- No RSS, HW checksum and TSO support
- No more than 8 queues per-IF (only one Queue Set per IF)
- HW statistics enabled
- Works in all available MAC modes (1,10,20,40G)
- Style converted to BSD according to style(9)
- The code brings lmac_if interface used by the BGX driver to
update its logical MACs state.
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
This import brings following components of the Linux driver:
- Thunder BGX (programmable MAC)
- Physical Function driver
- Virtual Function driver
- Headers
Revision: 1.0
Obtained from: Cavium
License information: Cavium provided these files under BSD license
