This is being done to fix breakage with make distribution with read-only
source trees as make distribution doesn't use make obj like building
tests/ does in all cases
Reported by: Wolfgang Zenker <wolfgang@lyxys.ka.sub.org>
Suggested by: jhb
X-MFC with: r282059
MFC after: 1 week
Also return error if TSO is requested without Tx checksum offload.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2564
It just affects capabilities of the created VLAN interface.
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2563
If TxQ lock is obtained, deferred packet list shold be serviced even if
the packet addition fails because of overflow.
Without the patch freeze happens if:
- queue is not blocked (i.e. completion does not trigger unblock and service)
- put-list overflow (1024 entries)
- sfxge_tx_packet_add() acquires TxQ lock just as it is released it in
sfxge_tx_qdpl_service() on the second CPU but before pending check
- sfxge_tx_packet_add() swizzles put-list to get-list, fails because of
non-tcp get-list overflow and returns without packet list service
- sfxge_tx_qdpl_service() on the second CPU checks that there are no
pending packets in the put-list and returns
Other possible solution is to guaranee that maximum length of the put-list
is less than maximum length of any get-list.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2562
Update to tzdata2015c:
Release 2015c - 2015-04-11 08:55:55 -0700
Changes affecting future time stamps
Egypt's spring-forward transition is at 24:00 on April's last Thursday,
not 00:00 on April's last Friday. 2015's transition will therefore be on
Thursday, April 30 at 24:00, not Friday, April 24 at 00:00. Similar fixes
apply to 2026, 2037, 2043, etc. (Thanks to Steffen Thorsen.)
Update to tzdata2015c:
Release 2015c - 2015-04-11 08:55:55 -0700
Changes affecting future time stamps
Egypt's spring-forward transition is at 24:00 on April's last Thursday,
not 00:00 on April's last Friday. 2015's transition will therefore be on
Thursday, April 30 at 24:00, not Friday, April 24 at 00:00. Similar fixes
apply to 2026, 2037, 2043, etc. (Thanks to Steffen Thorsen.)
Obtained from: ftp://ftp.iana.org/tz/releases/
Previously, ubldr would use the virtual addresses in the elf headers by
masking off the high bits and assuming the result was a physical address
where the kernel should be loaded. That would sometimes discard
significant bits of the physical address, but the effects of that were
undone by archsw copy code that would find a large block of memory and
apply an offset to the source/dest copy addresses. The result was that
things were loaded at a different physical address than requested by the
higher code layers, but that worked because other adjustments were applied
later (such as when jumping to the entry point). Very confusing, and
somewhat fragile.
Now the archsw copy routines are just simple copies, and instead
archsw.arch_loadaddr is implemented to choose a load address. The new
routine uses some of the code from the old offset-translation routine to
find the largest block of ram, but it excludes ubldr itself from that
range, and also excludes If ubldr splits the largest block of ram in
two, the kernel is loaded into the bottom of whichever resulting block is
larger.
As part of eliminating ubldr itself from the ram ranges, export the heap
start/end addresses in a pair of new global variables.
This change means that the virtual addresses in the arm kernel elf headers
now have no meaning at all, except for the entry point address. There is
an implicit assumption that the entry point is in the first text page, and
that the address in the the header can be turned into an offset by masking
it with PAGE_MASK. In the future we can link all arm kernels at a virtual
address of 0xC0000000 with no need to use any low-order part of the
address to influence where in ram the kernel gets loaded.
1. Align to a 64-bit address so 64-bit data will be correctly aligned.
2. Add a comment explaining why.
3. Remove an unneeded value from the struct.
This fixes an issue where the struct may not be correctly aligned on the
stack in the syscall function. This may lead to accesing a 64-bit value
at a non 64-bit. This will raise an exception and panic the kernel.
We have been lucky where on arm and armv6 both clang and gcc correctly
align the data, even without us asking to, however, on armeb with clang to
not be the case. This tells the compiler we really do need this to be
aligned.
Reported and tested by: jmg (on armeb with clang)
MFC after: 1 Week [1, 2]
when loader(8) passed physical addresses in loader metadata for arm, but
that is no longer true; all metadata has already been adjusted to vitual
addresses by loader.
I can't track down the exact revision in loader where a change from physical
to virtual metadata addresses happened. The code involved is very twisty
and complicated. I suspect the change was an unintended consequence of the
r247301, r247413, r248118 series of changes I made a couple years ago.
and qone[f]() were marked as __inline, but their forward
declarations were not updated. Fix the forward declarations
to match the actual function declarations.
Requested by: bde
which declares a dependency on siftr(4). This is necessitated by a
reference to struct pkt_node, which is defined in siftr(4): otherwise,
dtrace(1) will return an error during startup if siftr.ko is not loaded.
return an error if one of the depends_on directives in a library is not
satisfied. In this case, libdtrace is supposed to ignore the library and
carry on. However, the remainder of the library may still be buffered by
the lexer, causing libdtrace to erroneously continue processing it on the
next call to yyparse(). Fix this by explicitly flushing the input buffer
each time the compiler state is reset.
MFC after: 3 weeks
comment to this effect and switch the default. My old AT91SAM9G20
now boots, fsck's the SD card and runs w/o an issue for the first
time since a 9.1-ish stable build I did a few years ago.
Problems with unmapped I/O:
o un-page-aligned I/O requests to devices fail (notably fsck
and newfs).
o write-back caching was totally broken. write-through caching
needed to be enabled.
o Even page-aligned I/O requests sometimes failed for reasons
not thoroughly investigated.
Suggested by: ian@
MFC after: 2 days
systems that are automounted, since that configuration
isn't supported. This still allows the export, since
two emails I received felt that this should not be
disabled. It sends the message to syslog(LOG_ERR..), so that
it goes to the same places as the other messages related
to /etc/exports problems, even though it is a warning and not an error.
Reviewed by: trasz
MFC after: 2 weeks
The driver uses ifm_data to save capabilities mask calculated during
initialization when supported phy modes are discovered.
The patch simply calculates it when either media or options are changed.
Reviewed by: glebius
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2540
Without these CFLAGS settings a cross-compile won't find the headers
anywhere.
Tested:
* mips (32, big endian) cross-build w/ LOCAL_DIRS including these
tools.
It is required for the next patch which adds dependency of TSO
capabilities from Tx checksum offloads.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2553
* simplify channel logic for determining RF gain setting in scan setup
* don't set TX timer on error
* free node references for unsent frames on device stop
* set maxfrags to IWN_MAX_SCATTER-1 (first segment is used by TX command)
* add missing IWN_UNLOCK() from interrupt path when the hardware
disappears.
* pass control frames to host
* nitems() instead of local macro
Tested:
* Intel 5100, STA mode
PR: kern/196264
Submitted by: Andriy Voskoboinyk <s3erios@gmail.com>
It is a preparation to the next patch which will service packet queue even
if packet addtion fails.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2552
Now each branch has one and only one possible TxQ lock state.
It simplifies understanding of the code.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2551
We can't disable it in HW, but we can ignore result.
Discard Rx descriptor checksum flags if Rx checksum offload is off.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D2544
previous releases.
Also add a stdlib.h wrapper, which declares the function, otherwise the
compiler may assume it returns int, which can cause segfaults on LP64
architectures.
Reviewed by: bapt
Differential Revision: https://reviews.freebsd.org/D2558
This lets the compiler know about the alignment of pointers returned
by aligned_alloc(3), posix_memalign(3). and contigmalloc(9)
Currently this is only supported in recent gcc but we are ready to
use it if clang implements it.
Relnotes: yes
In general it is bad practice to use the gnu_inline attribute but we
will need it in special cases like FORTIFY_SOURCE. In this specific
case it is also useful to have the "artificial" attribute:
"This attribute is useful for small inline wrappers which if possible
should appear during debugging as a unit, depending on the debug info
format it will either mean marking the function as artificial or using the
caller location for all instructions within the inlined body."
This attribute appears to be currently implemented only in GCC. Use it
only in conjuntion with gnu_inline in the cases where it is available,
which is similar in spirit in how it's used in glibc.
The Alpine Platform-On-Chip offers multicore processing
(quad ARM Cortex-A15), 1/10Gb Ethernet, SATA 3, PCI-E 3,
DMA engines, Virtualization, Advanced Power Management and other.
This code drop involves basic platform support including:
SMP, IRQs, SerDes, SATA. As of now it is missing the PCIe support.
Part of the functionality is provided by the low-level code (HAL)
delivered by the chip vendor (Annapurna Labs) and is a subject to
change in the future (is planned to be moved to sys/contrib directory).
The review log for this commit is available here:
https://reviews.freebsd.org/D2340
Reviewed by: andrew, ian, imp
Obtained from: Semihalf
Sponsored by: Annapurna Labs
Perform cache writebacks and invalidations in the correct (inner to outer
or vice versa) order, and add comments that explain that.
Consistantly use 'va' as the variable name for virtual addresses.
Submitted by: Michal Meloun <meloun@miracle.cz>
