have got the following:
Back out the changes in the previous revision. Function-like macros
were replaced by compound statements that work in less contexts.
Unoformize idempotency #ifdef.
Restore the simple leap year calculation as a macro and document it so
that it doesn't become complicated again. The simple version works
for all leap years covered by 32-bit time_t's. The complicated version
doesn't work for all leap years covered by 64-bit time_t's since among
other reasons, the solar system is not stable for long enough.
Fix declarations.
Nuke spinwait().
This code is mostly taken from the 1.1 port (which was in turn taken from
Dave Mills's kern.tar.Z example). A few significant differences:
1) ntp_gettime() is now a MIB variable rather than a system call. A few
fiddles are done in libc to make it behave the same.
2) mono_time does not participate in the PLL adjustments.
3) A new interface has been defined (in <machine/clock.h>) for doing
possibly machine-dependent things around the time of the clock update.
This is used in Pentium kernels to disable interrupts, set `time', and
reset the CPU cycle counter as quickly as possible to avoid jitter in
microtime(). Measurements show an apparent resolution of a bit more than
8.14usec, which is reasonable given system-call overhead.
Removed inb function since it's more correctly in pio.h
Copied write_eflags and read_eflags over from npx.c
(Some changes to the macros suggested by Bruce were not made at this
time since his suggestions probably apply to all the macros and
these inlined/macro definitions need a lot of cleaning up at some
point in the future.)
Reviewed by: Bruce
Fix from Bruce Evans. There were missing sets of parantheses:
1. The checks for the standard data selectors were botched, so %ss == 0
and probably %cs == 0 were allowed. A fix is enclosed. The checks
for the standard selectors could be omitted without losing anything
since the standard selectors pass the valid_ldt_sel() tests.
320x200 256col VGA. This is nessesary for the iBCS stuff to work right.
(And we get the benefit of more video modes). Uses the videocard BIOS
to optain mode tables.
Added a "green" saver, switches off the syncs for "green" monitors.
Reviewed by:
Submitted by:
Obtained from:
don't hard-code netisr values in icu.s, but rather, use an array of
function pointers and set them all up in machdep.c for statically-linked
protocol families. (This will eventually be done differently.)
otherwise the machine will overflow the stack in a recursive fault loop
(causing the machine to spontaneously reboot because of the stack fault
that ultimately happens).
Submitted by: Inspired by Bruce Evans, but this change is different
than what he suggested.
if KERNEL is not defined. lib/msun/i387/*.S include asmacros.h to
get the definitions of ENTRY(), etc. This is bogus since asmacros.h
is only supposed to give definitions suitable for the kernel. The
current definitions for the kernel almost worked but are missing
the ".type" declarations. This caused the linker to print warnings
about doubtful relocations for almost anything linked to libm[sun].
Uniformize name and use of idempotence identifier.
the Mach/i386 version of the BSD/vax(?) <machine/psl.h>. The Mach
version has slightly better names for many macros but is now out of
date and little used. It was originally used even less (for spelling
PSL_T as EFL_TF in <machine/db_machdep.h>).
negation whenever we access memory between 640k and 1M.
Original code from NetBSD 1.0-BETA. The exact origins are unclear but
Theo de Raadt, Charles, and Michael V. may have contributed to it.
Submitted by: pst
Submitted by:
1) if_ie.c:
Changed a printf and put a space in it. Formerly the "<3C507>"
confused the syslog. He tried to see that as the priority to
log that message.
2) isa_device.h:
Changed the iobase variable from short to u_short. EISA
Adresses can go up to 0xf000 and the sign extension doesn't
look good in the probe output. Example:
ep1 at 0xffff8000-0xffff8000f is not good :-), i like more a
ep1 at 0x8000-0x8000f.
3) isa.c:
Changed a string constant from "probe" to "prob", it gets
later already an "ed" tagged on the end.
with BOUNCE_BUFFERS. This is more intuitive, and is better for future
multiplatform support. Added BOUNCE_BUFFERS option to the GENERIC and
LINT kernel config files.
in your kernel config now).
2) Added ps ddb function from 1.1.5. Cleaned it up a bit and moved into its
own file.
3) Added \r handing in db_printf.
4) Added missing memory usage stats to statclock().
5) Added dummy function to pseudo_set so it will be emitted if there
are no other pseudo declarations.
Changed u_int_inb to just inb and deleted define.
The code generated is identical to that generated with the cast so
the problem was obviously fixed at some point after gcc 1.4
Reviewed by:
Submitted by:
hosing syscons. Doesn anyone know anything about this
or can we just delete it now?
/*
* This roundabout method of returning a u_char helps stop gcc-1.40 from
* generating unnecessary movzbl's.
*/
#ifdef disable_for_gcc-2_6_0
#define inb(port) ((u_char) u_int_inb(port))
#endif
static inline u_int
u_int_inb(u_int port)
{
u_char data;
/*
* We use %%dx and not %1 here because i/o is done at %dx and
not at
* %edx, while gcc-2.2.2 generates inferior code (movw instead
of movl)
* if we tell it to load (u_short) port.
*/
__asm __volatile("inb %%dx,%0" : "=a" (data) : "d" (port));
return data;
}
Reviewed by:
Submitted by:
machdep.c:
Changed printf's a little and call vfs_unmountall() if the sync was
successful.
cd9660_vfsops.c, ffs_vfsops.c, nfs_vfsops.c, lfs_vfsops.c:
Allow dismount of root FS. It is now disallowed at a higher level.
vfs_conf.c:
Removed unused rootfs global.
vfs_subr.c:
Added new routines vfs_unmountall and vfs_unmountroot. Filesystems
are now dismounted if the machine is properly rebooted.
ffs_vfsops.c:
Toggle clean bit at the appropriate places. Print warning if an
unclean FS is mounted.
ffs_vfsops.c, lfs_vfsops.c:
Fix bug in selecting proper flags for VOP_CLOSE().
vfs_syscalls.c:
Disallow dismounting root FS via umount syscall.
2. Hack.
Hack is to define RCSID() to null macro so that new msun stuff
will compile. This does NOT belong here, and I DON'T want it to
stay, I just need to put this here for now to enable msun and we need
to talk about what our RCSID story is supposed to be. We talked about
supporting RCSID() one day, and everyone seemed to like the idea
reasonably well of making it a macro you could just no-op this way,
but we never did anything. Now I see that JTCs code has it and I'm
loath to remove it or do anything until we've discussed it some more.
Well, so how about it? What's our story vis-a-vis RCSID() going to
be?
Submitted by: jkh
- Delete redundant declarations.
- Add -Wredundant-declarations to Makefile.i386 so they don't come back.
- Delete sloppy COMMON-style declarations of uninitialized data in
header files.
- Add a few prototypes.
- Clean up warnings resulting from the above.
NB: ioconf.c will still generate a redundant-declaration warning, which
is unavoidable unless somebody volunteers to make `config' smarter.
/usr/src/sys/i386/isa/clock.c:
o Garrett's statclock changes.
o Wire xxxintr, not Vclk.
o Wire using register_intr(), not setidt().
/usr/src/sys/i386/isa/icu.s:
o Garrett's statclock changes.
o Removed unused variable high_imask.
o Fake int 8 for rtc as well as int 0 for clk. Required for kernel
profiling with statclock, harmless otherwise.
/usr/src/sys/i386/isa/isa.c:
o Allow isdp->id_irq and other things in *isdp to be changed by
probes. Changing interrupts later requires direct calls to
register_intr() and unregister_intr() and more care.
ALLOW_CONFLICT_* is brought over from 1.1.5, except
ALLOW_CONFLICT_IRQ is not supported. IRQ conflict checking is
delayed until after probing so that drivers can change the IRQ
to a free one; real conflicts require more cooperation between
drivers to handle.
o Too many details to list.
o This file requires splitting and a lot more work.
/usr/src/sys/i386/isa/isa_device.h:
o Declare more things more completely.
/usr/src/sys/i386/isa/sio.c:
o Prepare to register interrupt handlers as fast.
/usr/src/sys/i386/isa/vector.s:
o Generate entry code for 16 fast interrupt handlers and 16 normal
interrupt handlers. Changed some constants to variables:
# $unit is now intr_unit[intr]. Type is int. Someday it should
be a cookie suitable for the handler (e.g., a struct com_s for
sio).
# $handler is now intr_handler[intr].
# intrcnt_actv[id_num] is now *intr_countp[intr]. The indirection
is required to get a contiguous range of counters for vmstat
and so that the drivers depend more in the driver than on the
interrupt number (drivers could take turns using an interrupt
and the counts would remain correct). There is a separate
counter for each device and for each stray interrupt. In
1.1.5, stray interrupt 7 clobbers the count for device 7 or
something worse if there is no device 7 :-(.
# mask is now intr_mask[intr] (was already indirect).
o Entry points are now _XintrI and _XfastintrI (I = intr = 0-15),
not _VdevU (U = unit).
o Removed BUILD_VECTORS stuff. There's a trace of it left for
the string table for vmstat but config now generates the
string in one piece because nothing more is required.
o Removed old handling of stray interrupts and older comments
about it.
Submitted by: Bruce Evans
not provide the full accuracy of a randomized statistical clock, it does
provide greater accuracy than the previous method, while not significantly
increasing overhead. It also provides profiling support at 1024 Hz.
You must re-compile config before making a new kernel, or you will end
up with unresolved symbols.
Reviewed uy: Bruce evans said it worked for him.
Delete the ifdef GPL_EMULATE case here and made the padding work for
both types of emulators so that there is no longer a need to compile
ps and friends new if you are using the GPL math emulator instead the
normal one.
``changes'' are actually not changes at all, but CVS sometimes has trouble
telling the difference.
This also includes support for second-directory compiles. This is not
quite complete yet, as `config' doesn't yet do the right thing. You can
still make it work trivially, however, by doing the following:
rm /sys/compile
mkdir /usr/obj/sys/compile
ln -s M-. /sys/compile
cd /sys/i386/conf
config MYKERNEL
cd ../../compile/MYKERNEL
ln -s /sys @
rm machine
ln -s @/i386/include machine
make depend
make
improvements via the new routines pmap_qenter/pmap_qremove and pmap_kenter/
pmap_kremove. These routine allow fast mapping of pages for those
architectures that have "normal" MMUs. Also included is a fix to the
pageout daemon to properly check a queue end condition.
Submitted by: John Dyson
me:
1) TLB flush optimization that effectively eliminates half of all of the
TLB flushes. This works by only flushing the TLB when a page is "present"
in memory (i.e. the valid bit is set in the page table entry). See section
5.3.5 of the Intel 386 Programmer's Reference Manual.
2) The handling of "CMAP" has been improved to catch attempts at multiple
simultaneous use.
John:
1) Added pmap_qenter/pmap_qremove functions for fast mapping of pages into
the kernel. This is for future optimizations and support for the upcoming
merged VM/buffer cache.
Reviewed by: John Dyson
From Bruce Evans:
fu[i]byte() checked the wrong register. This caused interesting behaviour
in the GPL math emulator. The emulator does not check the values returned
by fu*() or su*() (:-() and it interpreted the address of -12(%ebp) as
-1(%ebp). The same probably occurs for all signed 8-bit offsets from
registers.
I cleaned up the new bzero() a bit.
Vastly improved trap.c from me. This rewritten version has a variety of
features, amoung them: higher performance and much higher code quality.
support.s, cpufunc.h:
No longer use gs override to enforce range limits - compare directly
against VM_MAXUSER_ADDRESS instead. The old way caused problems in
preserving the gs selector...and this method is just as fast or faster.
