This commit includes only the kernel files, the rest of the files
will follow in a second commit.
Reviewed by: bz
Approved by: re
Supported by: Secure Computing
some cases, move to priv_check() if it was an operation on a thread and
no other flags were present.
Eliminate caller-side jail exception checking (also now-unused); jail
privilege exception code now goes solely in kern_jail.c.
We can't yet eliminate suser() due to some cases in the KAME code where
a privilege check is performed and then used in many different deferred
paths. Do, however, move those prototypes to priv.h.
Reviewed by: csjp
Obtained from: TrustedBSD Project
protocol entry points using functions named proto_getsockaddr and
proto_getpeeraddr rather than proto_setsockaddr and proto_setpeeraddr.
While it's true that sockaddrs are allocated and set, the net effect is
to retrieve (get) the socket address or peer address from a socket, not
set it, so align names to that intent.
It is built in the same module as IPv4 multicast forwarding, i.e. ip_mroute.ko,
if and only if IPv6 support is enabled for loadable modules.
Export IPv6 forwarding structs to userland netstat(1) via sysctl(9).
function, pru_close, to notify protocols that the file descriptor or
other consumer of a socket is closing the socket. pru_abort is now a
notification of close also, and no longer detaches. pru_detach is no
longer used to notify of close, and will be called during socket
tear-down by sofree() when all references to a socket evaporate after
an earlier call to abort or close the socket. This means detach is now
an unconditional teardown of a socket, whereas previously sockets could
persist after detach of the protocol retained a reference.
This faciliates sharing mutexes between layers of the network stack as
the mutex is required during the checking and removal of references at
the head of sofree(). With this change, pru_detach can now assume that
the mutex will no longer be required by the socket layer after
completion, whereas before this was not necessarily true.
Reviewed by: gnn
( and where appropriate the destruction) of the pcb mutex to the init/finit
functions of the pcb zones.
This allows locking of the pcb entries and race condition free comparison
of the generation count.
Rearrange locking a bit to avoid extra locking operation to update the generation
count in in_pcballoc(). (in_pcballoc now returns the pcb locked)
I am planning to convert pcb list handling from a type safe to a reference count
model soon. ( As this allows really freeing the PCBs)
Reviewed by: rwatson@, mohans@
MFC after: 1 week
pru_abort(), pru_detach(), and in_pcbdetach():
- Universally support and enforce the invariant that so_pcb is
never NULL, converting dozens of unnecessary NULL checks into
assertions, and eliminating dozens of unnecessary error handling
cases in protocol code.
- In some cases, eliminate unnecessary pcbinfo locking, as it is no
longer required to ensure so_pcb != NULL. For example, in protocol
shutdown methods, and in raw IP send.
- Abort and detach protocol switch methods no longer return failures,
nor attempt to free sockets, as the socket layer does this.
- Invoke in_pcbfree() after in_pcbdetach() in order to free the
detached in_pcb structure for a socket.
MFC after: 3 months
rather than an error. Detaches do not "fail", they other occur or
the protocol flags SS_PROTOREF to take ownership of the socket.
soclose() no longer looks at so_pcb to see if it's NULL, relying
entirely on the protocol to decide whether it's time to free the
socket or not using SS_PROTOREF. so_pcb is now entirely owned and
managed by the protocol code. Likewise, no longer test so_pcb in
other socket functions, such as soreceive(), which have no business
digging into protocol internals.
Protocol detach routines no longer try to free the socket on detach,
this is performed in the socket code if the protocol permits it.
In rts_detach(), no longer test for rp != NULL in detach, and
likewise in other protocols that don't permit a NULL so_pcb, reduce
the incidence of testing for it during detach.
netinet and netinet6 are not fully updated to this change, which
will be in an upcoming commit. In their current state they may leak
memory or panic.
MFC after: 3 months
than an int, as an error here is not meaningful. Modify soabort() to
unconditionally free the socket on the return of pru_abort(), and
modify most protocols to no longer conditionally free the socket,
since the caller will do this.
This commit likely leaves parts of netinet and netinet6 in a situation
where they may panic or leak memory, as they have not are not fully
updated by this commit. This will be corrected shortly in followup
commits to these components.
MFC after: 3 months
- most of the kernel code will not care about the actual encoding of
scope zone IDs and won't touch "s6_addr16[1]" directly.
- similarly, most of the kernel code will not care about link-local
scoped addresses as a special case.
- scope boundary check will be stricter. For example, the current
*BSD code allows a packet with src=::1 and dst=(some global IPv6
address) to be sent outside of the node, if the application do:
s = socket(AF_INET6);
bind(s, "::1");
sendto(s, some_global_IPv6_addr);
This is clearly wrong, since ::1 is only meaningful within a single
node, but the current implementation of the *BSD kernel cannot
reject this attempt.
Submitted by: JINMEI Tatuya <jinmei__at__isl.rdc.toshiba.co.jp>
Obtained from: KAME
in6p_outputopts at the entrance of the functions. this trick was
necessary when we passed an in6 pcb to in6_embedscope(), within which
the in6p_outputopts member was used, but we do not use this kind of
interface any more.
Submitted by: Keiichi SHIMA <keiichi__at__iijlab.net>
Obtained from: KAME
structures, allowing in6_pcbnotify() to lock the pcbinfo and each
inpcb that it notifies of ICMPv6 events. This prevents inpcb
assertions from firing when IPv6 generates and delievers event
notifications for inpcbs.
Reported by: kuriyama
Tested by: kuriyama
synchronizing IPv6 protocol control blocks and lists. These changes
are modeled on the inpcb locking for IPv4, submitted by Jennifer Yang,
and committed by Jeffrey Hsu. With these locking changes, IPv6 use of
inpcbs is now substantially more MPSAFE, and permits IPv4 inpcb locking
assertions to be run in the presence of IPv6 compiled into the kernel.
the routing table. Move all usage and references in the tcp stack
from the routing table metrics to the tcp hostcache.
It caches measured parameters of past tcp sessions to provide better
initial start values for following connections from or to the same
source or destination. Depending on the network parameters to/from
the remote host this can lead to significant speedups for new tcp
connections after the first one because they inherit and shortcut
the learning curve.
tcp_hostcache is designed for multiple concurrent access in SMP
environments with high contention and is hash indexed by remote
ip address.
It removes significant locking requirements from the tcp stack with
regard to the routing table.
Reviewed by: sam (mentor), bms
Reviewed by: -net, -current, core@kame.net (IPv6 parts)
Approved by: re (scottl)
the MAC label referenced from 'struct socket' in the IPv4 and
IPv6-based protocols. This permits MAC labels to be checked during
network delivery operations without dereferencing inp->inp_socket
to get to so->so_label, which will eventually avoid our having to
grab the socket lock during delivery at the network layer.
This change introduces 'struct inpcb' as a labeled object to the
MAC Framework, along with the normal circus of entry points:
initialization, creation from socket, destruction, as well as a
delivery access control check.
For most policies, the inpcb label will simply be a cache of the
socket label, so a new protocol switch method is introduced,
pr_sosetlabel() to notify protocols that the socket layer label
has been updated so that the cache can be updated while holding
appropriate locks. Most protocols implement this using
pru_sosetlabel_null(), but IPv4/IPv6 protocols using inpcbs use
the the worker function in_pcbsosetlabel(), which calls into the
MAC Framework to perform a cache update.
Biba, LOMAC, and MLS implement these entry points, as do the stub
policy, and test policy.
Reviewed by: sam, bms
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
- share policy-on-socket for listening socket.
- don't copy policy-on-socket at all. secpolicy no longer contain
spidx, which saves a lot of memory.
- deep-copy pcb policy if it is an ipsec policy. assign ID field to
all SPD entries. make it possible for racoon to grab SPD entry on
pcb.
- fixed the order of searching SA table for packets.
- fixed to get a security association header. a mode is always needed
to compare them.
- fixed that the incorrect time was set to
sadb_comb_{hard|soft}_usetime.
- disallow port spec for tunnel mode policy (as we don't reassemble).
- an user can define a policy-id.
- clear enc/auth key before freeing.
- fixed that the kernel crashed when key_spdacquire() was called
because key_spdacquire() had been implemented imcopletely.
- preparation for 64bit sequence number.
- maintain ordered list of SA, based on SA id.
- cleanup secasvar management; refcnt is key.c responsibility;
alloc/free is keydb.c responsibility.
- cleanup, avoid double-loop.
- use hash for spi-based lookup.
- mark persistent SP "persistent".
XXX in theory refcnt should do the right thing, however, we have
"spdflush" which would touch all SPs. another solution would be to
de-register persistent SPs from sptree.
- u_short -> u_int16_t
- reduce kernel stack usage by auto variable secasindex.
- clarify function name confusion. ipsec_*_policy ->
ipsec_*_pcbpolicy.
- avoid variable name confusion.
(struct inpcbpolicy *)pcb_sp, spp (struct secpolicy **), sp (struct
secpolicy *)
- count number of ipsec encapsulations on ipsec4_output, so that we
can tell ip_output() how to handle the packet further.
- When the value of the ul_proto is ICMP or ICMPV6, the port field in
"src" of the spidx specifies ICMP type, and the port field in "dst"
of the spidx specifies ICMP code.
- avoid from applying IPsec transport mode to the packets when the
kernel forwards the packets.
Tested by: nork
Obtained from: KAME
(aka RFC2292bis). Though I believe this commit doesn't break
backward compatibility againt existing binaries, it breaks
backward compatibility of API.
Now, the applications which use Advanced Sockets API such as
telnet, ping6, mld6query and traceroute6 use RFC3542 API.
Obtained from: KAME
control block. Allow the socket and tcpcb structures to be freed
earlier than inpcb. Update code to understand an inp w/o a socket.
Reviewed by: hsu, silby, jayanth
Sponsored by: DARPA, NAI Labs