umich copyright is asserting.
Clarify that the copyright I'm asserting is the standard Berkeley
license.
Remove Giant assertions from AARP and DDP input routines.
SOCK_LOCK(so):
- Hold socket lock over calls to MAC entry points reading or
manipulating socket labels.
- Assert socket lock in MAC entry point implementations.
- When externalizing the socket label, first make a thread-local
copy while holding the socket lock, then release the socket lock
to externalize to userspace.
reference count:
- Assert SOCK_LOCK(so) macros that directly manipulate so_count:
soref(), sorele().
- Assert SOCK_LOCK(so) in macros/functions that rely on the state of
so_count: sofree(), sotryfree().
- Acquire SOCK_LOCK(so) before calling these functions or macros in
various contexts in the stack, both at the socket and protocol
layers.
- In some cases, perform soisdisconnected() before sotryfree(), as
this could result in frobbing of a non-present socket if
sotryfree() actually frees the socket.
- Note that sofree()/sotryfree() will release the socket lock even if
they don't free the socket.
Submitted by: sam
Sponsored by: FreeBSD Foundation
Obtained from: BSD/OS
1. rt_check() cleanup:
rt_check() is only necessary for some address families to gain access
to the corresponding arp entry, so call it only in/near the *resolve()
routines where it is actually used -- at the moment this is
arpresolve(), nd6_storelladdr() (the call is embedded here),
and atmresolve() (the call is just before atmresolve to reduce
the number of changes).
This change will make it a lot easier to decouple the arp table
from the routing table.
There is an extra call to rt_check() in if_iso88025subr.c to
determine the routing info length. I have left it alone for
the time being.
The interface of arpresolve() and nd6_storelladdr() now changes slightly:
+ the 'rtentry' parameter (really a hint from the upper level layer)
is now passed unchanged from *_output(), so it becomes the route
to the final destination and not to the gateway.
+ the routines will return 0 if resolution is possible, non-zero
otherwise.
+ arpresolve() returns EWOULDBLOCK in case the mbuf is being held
waiting for an arp reply -- in this case the error code is masked
in the caller so the upper layer protocol will not see a failure.
2. arpcom untangling
Where possible, use 'struct ifnet' instead of 'struct arpcom' variables,
and use the IFP2AC macro to access arpcom fields.
This mostly affects the netatalk code.
=== Detailed changes: ===
net/if_arcsubr.c
rt_check() cleanup, remove a useless variable
net/if_atmsubr.c
rt_check() cleanup
net/if_ethersubr.c
rt_check() cleanup, arpcom untangling
net/if_fddisubr.c
rt_check() cleanup, arpcom untangling
net/if_iso88025subr.c
rt_check() cleanup
netatalk/aarp.c
arpcom untangling, remove a block of duplicated code
netatalk/at_extern.h
arpcom untangling
netinet/if_ether.c
rt_check() cleanup (change arpresolve)
netinet6/nd6.c
rt_check() cleanup (change nd6_storelladdr)
address discovery and caching (similar to inet ARP). Use a single
global mutex, aarptab_mtx, to protect the table. Remove spl/spx.
Tested by: Bob Bishop <rb@gid.co.uk>
to other files in netatalk:
Log:
Since I have my hands all over netatalk adding locking and restructuring
it, cinch the file's style closer to style(9) with regard to parenthesis:
s/( /(/g
s/ )/)/g
s/return(/return (/g
s/return 0/return (0)/
s/return 1/return (1)/
from ddp_usrreq.c. Functions moved are:
at_pcballoc()
at_pcbconnect()
at_pcbdetach()
at_pcbdisconnect()
at_pcbsetaddr()
at_sockaddr()
Also moved are ddp_ports and ddpcb, global variables associated with DDP
pcbs. This makes PCB implementation more parallel to inet, inet6, and
ipx.
While there, remove (caddr_t) casting of ethernet addresses, which
among other things discards the qualifier. This makes it clear that
atmulticastaddr does not require synchronization.
functions in kern_socket.c.
Rename the "canwait" field to "mflags" and pass M_WAITOK and M_NOWAIT
in from the caller context rather than "1" or "0".
Correct mflags pass into mac_init_socket() from previous commit to not
include M_ZERO.
Submitted by: sam
caused crashes, typically during shutdown, because the second free
referenced a mutex that had been destroyed.
Tested by: several
Approved by: re (scottl)
the MAC label referenced from 'struct socket' in the IPv4 and
IPv6-based protocols. This permits MAC labels to be checked during
network delivery operations without dereferencing inp->inp_socket
to get to so->so_label, which will eventually avoid our having to
grab the socket lock during delivery at the network layer.
This change introduces 'struct inpcb' as a labeled object to the
MAC Framework, along with the normal circus of entry points:
initialization, creation from socket, destruction, as well as a
delivery access control check.
For most policies, the inpcb label will simply be a cache of the
socket label, so a new protocol switch method is introduced,
pr_sosetlabel() to notify protocols that the socket layer label
has been updated so that the cache can be updated while holding
appropriate locks. Most protocols implement this using
pru_sosetlabel_null(), but IPv4/IPv6 protocols using inpcbs use
the the worker function in_pcbsosetlabel(), which calls into the
MAC Framework to perform a cache update.
Biba, LOMAC, and MLS implement these entry points, as do the stub
policy, and test policy.
Reviewed by: sam, bms
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
whether or not the isr needs to hold Giant when running; Giant-less
operation is also controlled by the setting of debug_mpsafenet
o mark all netisr's except NETISR_IP as needing Giant
o add a GIANT_REQUIRED assertion to the top of netisr's that need Giant
o pickup Giant (when debug_mpsafenet is 1) inside ip_input before
calling up with a packet
o change netisr handling so swi_net runs w/o Giant; instead we grab
Giant before invoking handlers based on whether the handler needs Giant
o change netisr handling so that netisr's that are marked MPSAFE may
have multiple instances active at a time
o add netisr statistics for packets dropped because the isr is inactive
Supported by: FreeBSD Foundation
if_xname, if_dname, and if_dunit. if_xname is the name of the interface
and if_dname/unit are the driver name and instance.
This change paves the way for interface renaming and enhanced pseudo
device creation and configuration symantics.
Approved By: re (in principle)
Reviewed By: njl, imp
Tested On: i386, amd64, sparc64
Obtained From: NetBSD (if_xname)
drain routines are done by swi_net, which allows for better queue control
at some future point. Packets may also be directly dispatched to a netisr
instead of queued, this may be of interest at some installations, but
currently defaults to off.
Reviewed by: hsu, silby, jayanth, sam
Sponsored by: DARPA, NAI Labs
Label link layer mbufs as they are created for transmission, check
mbufs before delivering them to sockets, label mbufs as they are created
from sockets, and preserve mbuf labels if mbufs are copied.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
o Add a mutex (sb_mtx) to struct sockbuf. This protects the data in a
socket buffer. The mutex in the receive buffer also protects the data
in struct socket.
o Determine the lock strategy for each members in struct socket.
o Lock down the following members:
- so_count
- so_options
- so_linger
- so_state
o Remove *_locked() socket APIs. Make the following socket APIs
touching the members above now require a locked socket:
- sodisconnect()
- soisconnected()
- soisconnecting()
- soisdisconnected()
- soisdisconnecting()
- sofree()
- soref()
- sorele()
- sorwakeup()
- sotryfree()
- sowakeup()
- sowwakeup()
Reviewed by: alfred
Requested by: bde
Since locking sigio_lock is usually followed by calling pgsigio(),
move the declaration of sigio_lock and the definitions of SIGIO_*() to
sys/signalvar.h.
While I am here, sort include files alphabetically, where possible.
most cases NULL is passed, but in some cases such as network driver locks
(which use the MTX_NETWORK_LOCK macro) and UMA zone locks, a name is used.
Tested on: i386, alpha, sparc64
general cleanup of the API. The entire API now consists of two functions
similar to the pre-KSE API. The suser() function takes a thread pointer
as its only argument. The td_ucred member of this thread must be valid
so the only valid thread pointers are curthread and a few kernel threads
such as thread0. The suser_cred() function takes a pointer to a struct
ucred as its first argument and an integer flag as its second argument.
The flag is currently only used for the PRISON_ROOT flag.
Discussed on: smp@
vnodes. This will hopefully serve as a base from which we can
expand the MP code. We currently do not attempt to obtain any
mutex or SX locks, but the door is open to add them when we nail
down exactly how that part of it is going to work.
Note ALL MODULES MUST BE RECOMPILED
make the kernel aware that there are smaller units of scheduling than the
process. (but only allow one thread per process at this time).
This is functionally equivalent to teh previousl -current except
that there is a thread associated with each process.
Sorry john! (your next MFC will be a doosie!)
Reviewed by: peter@freebsd.org, dillon@freebsd.org
X-MFC after: ha ha ha ha
This is because calls with M_WAIT (now M_TRYWAIT) may not wait
forever when nothing is available for allocation, and may end up
returning NULL. Hopefully we now communicate more of the right thing
to developers and make it very clear that it's necessary to check whether
calls with M_(TRY)WAIT also resulted in a failed allocation.
M_TRYWAIT basically means "try harder, block if necessary, but don't
necessarily wait forever." The time spent blocking is tunable with
the kern.ipc.mbuf_wait sysctl.
M_WAIT is now deprecated but still defined for the next little while.
* Fix a typo in a comment in mbuf.h
* Fix some code that was actually passing the mbuf subsystem's M_WAIT to
malloc(). Made it pass M_WAITOK instead. If we were ever to redefine the
value of the M_WAIT flag, this could have became a big problem.
before adding/removing packets from the queue. Also, the if_obytes and
if_omcasts fields should only be manipulated under protection of the mutex.
IF_ENQUEUE, IF_PREPEND, and IF_DEQUEUE perform all necessary locking on
the queue. An IF_LOCK macro is provided, as well as the old (mutex-less)
versions of the macros in the form _IF_ENQUEUE, _IF_QFULL, for code which
needs them, but their use is discouraged.
Two new macros are introduced: IF_DRAIN() to drain a queue, and IF_HANDOFF,
which takes care of locking/enqueue, and also statistics updating/start
if necessary.
