o Add "allow" command:
"allow users a b c" gives access to users a, b and c.
"allow modes auto" gives those users access to auto mode only.
"allow users *" and "allow modes *" are accepted.
No users and all modes are allowed by default.
UID 0 can do anything.
o Set the current label with the "load" and "dial" commands
so that the call to ppp.linkdown makes sense.
o Up the verison number.
o Don't OR MODE_AUTO for -background and -ddial.
o Don't OR MODE_INTER when we get a diagnostic connection.
o Allow up to 40 args per line (was 20).
o "set ifaddr" only changes the interface in AUTO mode (with other
modes, it happens after IPCP negotiation).
o Sort command descriptions in the man page.
o Support -dedicated mode where we just talk ppp forever (no login etc).
Stay as the invoking uid as much as possible.
Execution as a normal user is still forbidden for now,
so these changes are pretty ineffective.
The next commit will implement the modifications suggested
on -hackers a number of days ago.
ppp.secret to get a key value based on the peers name,
then send the value of AuthName with the encrypted result.
This is *way* too confusing.
Instead, always use AuthName and AuthKey as the documentation
says.
o Report modem connect time properly
o Report bytes in/out over physical media
o Fix phases (TERMINATE is *higher than* DEAD)
o Do a LayerFinish from LcpDown
o Bring down IPCP & CCP when we enter PHASE_TERMINATE
o Give a new prompt when we go to PHASE_DEAD
o Stop the modem timer properly when idle
o Treat sig 15 like an exiting carrier loss
o Log (DEBUG) offline & online transitions
o Add missing $Id$s
o Move extern decls from .c -> .h files
o Staticize
o Remove #includes from .h files
o style(9)ify includes
o bcopy -> memcpy
bzero -> memset
bcmp -> memcmp
index -> strchr
rindex -> strrchr
o Move timeout.h -> timer.h (making it consistent w/ timer.c)
o Add -Wmissing-prototypes
Without this, in -auto mode, we stay in ST_STOPPING
and never check our dial filters to see if it's time
to bring the line up again.
This may make "set stopped" redundant.
Support VJ slot id compression.
Previously, ppp would negotiate a max slot between 2 & 15
(if asked), and would agree to slot id compression (if asked).
It would then proceed to use 16 slots and no compression
anyway. The result was a rather unusable connection.
o LcpLayerDown() no longer does a NewPhase(PHASE_TERMINATE).
Instead, it's done in LcpLayerFinish(). LayerFinish() gets
called by the FSM after the LCP FSM goes through the Stopping
and Stopped states.
o -direct and -background mode exit at PHASE_TERMINATE, not
PHASE_DEAD.
The result is that LCP, CCP & IPCP are brought down cleanly on both
sides of the link (not just our side). Killing ppp rather than just
closing it still makes it get out after the LCP SendTerminateReq().
I'll have a look at that soon. We're probably not actually sending
the REQ :-(
