- Run the adapter's tick at 1Hz and remove link state checks from it.
Instead, have each port check its link state. Delay the check so that
it takes place slightly after the driver is notified of a change in
link state. This is a cheap way to debounce these notifications if
many are received in rapid succession. POLL_LINK_1ST_TIME flag can
also be eliminated as a side effect of these changes.
- Do not reset the PHY when link goes down.
- Clear port's link_fault flag if the PHY indicates link is down.
- get_link_status_r should leave speed and duplex alone when link is down.
MFC after: 1 month
checksum is enabled in sge_init_locked().
While I'm here do not set RX checksum bits in RX descriptor
initialization. It is controller's job to set these bits.
Tested by: xclin <xclin <> cs dot nctu dot edu dot tw >
The existing code only checked the alignment of the first mbuf and
didn't enforce the size constraints.
This commit introduces a simple function to check the alignment and
size of all mbufs in the list. This fixes the initial issue in the
PR.
PR: kern/148307
Reviewed by: gonzo@
Updated PTE/PDE macros from http://svn.freebsd.org/base/user/jmallett/octeon
Introduce pmap_segshift() macro, use pmap_segmap() in place of pmap_pde, and
remove pmap_pde().
Approved by: rrs (mentor)
Obtained from: jmallett@
a virtual-mode version for use on 64-bit systems, which have 32-bit
firmware implementations and require similar constraints on addressing
to the real-mode implementation.
flag is always provided, and unconditionally retry after sleep for the
busy page or failed allocation.
The intent is to remove VM_ALLOC_RETRY eventually.
Proposed and reviewed by: alc
do on i386. The consequences of not doing so on amd64 became apparent
with the introduction of the COUNT_IPIS and COUNT_XINVLTLB_HITS
options. Specifically, single-threaded applications were generating
unnecessary IPIs to shoot-down the TLB on other processors. However,
this is clearly nonsensical because a single-threaded application is
only running on the current processor. The reason that this happens
is that pmap_activate() is unable to properly update the old pmap's
field "pm_active" without the correct "curpmap". So, in effect, stale
bits in "pm_active" were leading pmap_protect(), pmap_remove(),
pmap_remove_pages(), etc. to flush the TLB contents on some arbitrary
processor that wasn't even running the same application.
Reviewed by: kib
MFC after: 3 weeks
- Fix a bug where thread may be in sleeping state but the wchan won't
be set, leading to an empty container for sleepq_type(). [0]
Sponsored by: Sandvine Incorporated
[0] Submitted by: Bryan Venteicher
<bryanv at daemoninthecloset dot org>
MFC after: 3 days
X-MFC: 209577
by timeout/error of one of probe commands, process may continue infinitely.
Make CAM ATA more robust to faulty devices and false positive detections,
abort probe after two restarts on timeouts or ten on other errors.
