when VM_ALLOC_WIRED is specified: set the PG_MAPPED bit in flags.
o In both vm_page_wire() and vm_page_allocate() add a comment saying
that setting PG_MAPPED does not belong there.
net.inet.tcp.rexmit_min (default 3 ticks equiv)
This sysctl is the retransmit timer RTO minimum,
specified in milliseconds. This value is
designed for algorithmic stability only.
net.inet.tcp.rexmit_slop (default 200ms)
This sysctl is the retransmit timer RTO slop
which is added to every retransmit timeout and
is designed to handle protocol stack overheads
and delayed ack issues.
Note that the *original* code applied a 1-second
RTO minimum but never applied real slop to the RTO
calculation, so any RTO calculation over one second
would have no slop and thus not account for
protocol stack overheads (TCP timestamps are not
a measure of protocol turnaround!). Essentially,
the original code made the RTO calculation almost
completely irrelevant.
Please note that the 200ms slop is debateable.
This commit is not meant to be a line in the sand,
and if the community winds up deciding that increasing
it is the correct solution then it's easy to do.
Note that larger values will destroy performance
on lossy networks while smaller values may result in
a greater number of unnecessary retransmits.
that pre-zeroes free pages.
o Remove GIANT_REQUIRED from some low-level page queue functions. (Instead
assertions on the page queue lock are being added to the higher-level
functions, like vm_page_wire(), etc.)
In collaboration with: peter
identify this gadget on the CPUID result alone, so I intend to activate
the necessary magic (i8254 frequency for instance) for it based on the
precense of the on-chip host to PCI bridge.
Use lmin(long, long), not min(u_int, u_int). This is a problem here on
ia64 which has *way* more than 2^32 pages of KVA. 281474976710655 pages
to be precice.
This allows one to select the method of 3.3V card detection from the
three possible choices (none (0), the "6710 way" (1) and the "6729
way" (2)). The default is the 6710 way, since it works in the most
cases. The datasheets for the 6722 suggest that the '29 way is more
correct, but experience has shown this method to cause some laptops to
hang solid. See source code for details until I update the man page.
Submitted by: shibata-san (chiharu shibata <chi@bd.mbn.or.jp>)
o It needs to have pcic_isa_intr intrrupt handler
o for pci interrupts, in the func interrupt handler it needs to check the isa
registers rather than the pci ones for card present.
o better commentary for some of the strangeness of the 6729 on pci
o fix some crunchy comments to better reflect reality.
With this I almost have the WL200 working, but an interrupt storm
after attach is causing problems for reasons unknown. This code
doesn't seem to break the normal clpd6729 case, and I'd like others
with 6729 cards to try to test it (there were some that were used for
external pccard slots in pci only systems).
to return a wired page.
o Use VM_ALLOC_WIRED within Alpha's pmap_growkernel(). Also, because
Alpha's pmap_growkernel() calls vm_page_alloc() from within a critical
section, specify VM_ALLOC_INTERRUPT instead of VM_ALLOC_SYSTEM. (Only
VM_ALLOC_INTERRUPT is implemented entirely with a spin mutex.)
o Assert that the page queues mutex is held in vm_page_wire()
on Alpha, just like the other platforms.
so it needs an explicit #include <machine/frame.h> to get 'struct
trapframe'. The fact that it needs this at this level is rather bogus
but it will not compile without it.
one second but it badly breaks throughput on networks with minor packet
loss.
Complaints by: at least two people tracked down to this.
MFC after: 3 days
on the Itanium2 system I have when we use up *all* of the initial 256MB
direct mapped region before we are ready to dynamically expand it.
The machine that I have has 4 cpus and a very big hole in the middle.
This makes the bogus '(last_address - first_address) / PAGE_SIZE'
calculations especially dangerous and caused many millions of initial
PV/PTE's to be preallocated.
o Add preliminary support for Cirrus Logic CL-PD6729 using PCI
interrupts. To use it you you need to set hw.pcic.pd6729_intr_path
to 2. This is allow us to still default to ISA intrrupt path for
this part (which is found much more often in laptops using ISA IRQs).
But some PCI cards have this part on them and this should allow them
to be used. It is untested on PCI, but it seems to not break the ISA
case.
o Better sysctl descriptions (I hope).
machine will result in approximately a 4.2% loss of performance (buildworld)
and approximately a 5% reduction in power consumption (when idle). Add XXX
note on how to really make hlt work (send an IPI to wakeup HLTed cpus on
a thread-schedule event? Generate an interrupt somehow?).
in the .h file. Make it static __inline to make sure that it doesn't
wind up defined in any files.
Also, fix a typo that said null_do_attach instead of null_do_probe.
1.93; henning; MA401RA wi card
1.92; millert; elsa XI-325 wi card
1.91; fgsch; gemplus cpr400 smartcard reader
1.90; mickey; Nokia c110/c111 is prism2 card
1.89-1.86 (similar to what we do already)
The value we use is still questionable for 440BX chipsets.
- When flushing the TLB just toggle the bit in question instead of writing
a magic value that could trash other unrelated bits.
the filelist_lock and check nfiles. This closes a race where we had to
unlock the filedesc to re-lock the filelist_lock.
Reported by: David Xu
Reviewed by: bde (mostly)
after a panic which is not an interrupt thread, or the thread which
caused the panic. Also, remove panicstr checks from msleep() and from
cv_wait() in order to allow threads to go to sleep and yeild the cpu
to the panicing thread, or to an interrupt thread which might
be doing the crashdump.
Reviewed by: jhb (and it was mostly his idea too)
support creation times such as UFS2) to the value of the
modification time if the value of the modification time is older
than the current creation time. See utimes(2) for further details.
Sponsored by: DARPA & NAI Labs.
