This means 'options NETGRAPH' is no longer necessary in order to get
netgraph-enabled Ethernet interfaces. This supports loading/unloading
the ng_ether.ko and attaching/detaching the Ethernet interface in any
order.
Add two new hooks 'upper' and 'lower' to allow access to the protocol
demux engine and the raw device, respectively. This enables bridging
to be defined as a netgraph node, if so desired.
Reviewed by: freebsd-net@freebsd.org
address on an interface. This basically allows you to do what my
little setmac module/utility does via ifconfig. This involves the
following changes:
socket.h: define SIOCSIFLLADDR
if.c: add support for SIOCSIFLLADDR, which resets the values in
the arpcom struct and sockaddr_dl for the specified interface.
Note that if the interface is already up, we need to down/up
it in order to program the underlying hardware's receive filter.
ifconfig.c: add lladdr command
ifconfig.8: document lladdr command
You can now force the MAC address on any ethernet interface to be
whatever you want. (The change is not sticky across reboots of course:
we don't actually reprogram the EEPROM or anything.) Actually, you
can reprogram the MAC address on other kinds of interfaces too; this
shouldn't be ethernet-specific (though at the moment it's limited to
6 bytes of address data).
Nobody ran up to me and said "this is the politically correct way to
do this!" so I don't want to hear any complaints from people who think
I could have done it more elegantly. Consider yourselves lucky I didn't
do it by having ifconfig tread all over /dev/kmem.
would be returned with a wrong value.
While we're here, get rid of unnecessary panic call.
PR: 17311, 12996, 14457
Submitted by: Patrick Bihan-Faou <patrick@mindstep.com>,
Kris Kennaway <kris@FreeBSD.org>
is triggered when qmail is used with INET6 enabled. The bug
manifests itself in that the space variable can become negative
and that in the comparison in the guards of the 2 loops, this was
not noticed because sizeof() returns an unsigned and thus the signed
variable gets promoted to unsigned. I decided not to make space
unsigned because I think we should guard against this from happening.
Thus panic() in case space becomes negative.
Approved by: jkh
Some LAN card chip for fxp is known to cause problem at
interface initialization with IPv6 enabled. It happens at
some delicate timing.
And also, just adding some DELAY before IPv6 address
autoconfiguration is known to avoid the problem.
Complete fix is changing the driver not to use interrupt at
multicast filter initialization, but trying such change in
this stage will be dangerous.
So I add some DELAY() only inside #ifdef INET6 part,
as temporal workaround only for 4.0.
Approbed by: jkh
Noticed by: Mattias Pantzare <pantzer@ludd.luth.se>
Obtained from: openbsd-tech mailing list
do not pollute the interface further.
o Run if_detach at splnet().
o Creatively swipe the relevant parts of the netatm atm_nif_detach
which will delete the relevant references to the interface going
away.
o be more careful about clearing addresses (this isn't a kludge)
o For AF_INET interfaces, call SIOCDIFFADDR to remove last(?) bit
of cruft.
Special cases for AF_INET shouldn't be here, but I didn't see a good
generic way of doing this. If I missed something, please let me know.
This gross hack makes pccard ejection stable for ethernet cards.
Submitted by: Atushi Onoe-san
packet divert at kernel for IPv6/IPv4 translater daemon
This includes queue related patch submitted by jburkhol@home.com.
Submitted by: queue related patch from jburkhol@home.com
Reviewed by: freebsd-arch, cvs-committers
Obtained from: KAME project
for IPv6 yet)
With this patch, you can assigne IPv6 addr automatically, and can reply to
IPv6 ping.
Reviewed by: freebsd-arch, cvs-committers
Obtained from: KAME project
This is inteded for to allow ifconfig to print various unstructured
information from an interface.
The data is returned from the kernel in ASCII form, see the comment in
if.h for some technicalities.
Canonical cut&paste example to be found in if_tun.c
Initial use:
Now tun* interfaces tell the PID of the process which opened them.
Future uses could be (volounteers welcome!):
Have ppp/slip interfaces tell which tty they use.
Make sync interfaces return their media state: red/yellow/blue
alarm, timeslot assignment and so on.
Make ethernets warn about missing heartbeats and/or cables
This means that the driver will add/delete routes when it knows it is
up/down, rather than have the generic code belive it is up if configured.
This is probably most useful for serial lines, although many PHY chips
could probably tell us if we're connected to the cable/hub as well.
This is a seriously beefed up chroot kind of thing. The process
is jailed along the same lines as a chroot does it, but with
additional tough restrictions imposed on what the superuser can do.
For all I know, it is safe to hand over the root bit inside a
prison to the customer living in that prison, this is what
it was developed for in fact: "real virtual servers".
Each prison has an ip number associated with it, which all IP
communications will be coerced to use and each prison has its own
hostname.
Needless to say, you need more RAM this way, but the advantage is
that each customer can run their own particular version of apache
and not stomp on the toes of their neighbors.
It generally does what one would expect, but setting up a jail
still takes a little knowledge.
A few notes:
I have no scripts for setting up a jail, don't ask me for them.
The IP number should be an alias on one of the interfaces.
mount a /proc in each jail, it will make ps more useable.
/proc/<pid>/status tells the hostname of the prison for
jailed processes.
Quotas are only sensible if you have a mountpoint per prison.
There are no privisions for stopping resource-hogging.
Some "#ifdef INET" and similar may be missing (send patches!)
If somebody wants to take it from here and develop it into
more of a "virtual machine" they should be most welcome!
Tools, comments, patches & documentation most welcome.
Have fun...
Sponsored by: http://www.rndassociates.com/
Run for almost a year by: http://www.servetheweb.com/
1:
s/suser/suser_xxx/
2:
Add new function: suser(struct proc *), prototyped in <sys/proc.h>.
3:
s/suser_xxx(\([a-zA-Z0-9_]*\)->p_ucred, \&\1->p_acflag)/suser(\1)/
The remaining suser_xxx() calls will be scrutinized and dealt with
later.
There may be some unneeded #include <sys/cred.h>, but they are left
as an exercise for Bruce.
More changes to the suser() API will come along with the "jail" code.
it used to be that way. I'm not sure that it's needed, but it does
walk the ifp list..
Incidently, there's nothing to sanity check the ifq_maxlen on loaded
interfaces..
i386 platform boots, it is no longer ISA-centric, and is fully dynamic.
Most old drivers compile and run without modification via 'compatability
shims' to enable a smoother transition. eisa, isapnp and pccard* are
not yet using the new resource manager. Once fully converted, all drivers
will be loadable, including PCI and ISA.
(Some other changes appear to have snuck in, including a port of Soren's
ATA driver to the Alpha. Soren, back this out if you need to.)
This is a checkpoint of work-in-progress, but is quite functional.
The bulk of the work was done over the last few years by Doug Rabson and
Garrett Wollman.
Approved by: core
before they got changed. This can help eliminate much of the
gymnastics drivers do in their ioctl routines to figure this out.
Remove commented out IFF_NOTRAILERS
Drivers should be updated if they get flagged by this message.
(The reason this is important is because we do not have a way
to catch this mistake for interfaces added after ifinit() runs.)
for possible buffer overflow problems. Replaced most sprintf()'s
with snprintf(); for others cases, added terminating NUL bytes where
appropriate, replaced constants like "16" with sizeof(), etc.
These changes include several bug fixes, but most changes are for
maintainability's sake. Any instance where it wasn't "immediately
obvious" that a buffer overflow could not occur was made safer.
Reviewed by: Bruce Evans <bde@zeta.org.au>
Reviewed by: Matthew Dillon <dillon@apollo.backplane.com>
Reviewed by: Mike Spengler <mks@networkcs.com>
ioctl() routine at the end of if_delmulti() so that interfaces with
hardware multicast filtering can update their filters in a timely
manner.
If the interface doesn't support hardware multicast filtering, then
reception of multicast frames is done using 'promiscious mode' or
'capture all multicast frames' mode and software filtering in the
kernel. In this case, it doesn't matter if if_delmulti() ever does
an SCIODELMULTI on the interface or not: if MULTICAST support is
enabled, then we join the 'all hosts' group when the interface is
configured, and remain in it until the interface is brought down.
Without hardware filtering, joining one group means joining all
groups, so it makes no difference if we call the SIOCDELMULTI
routine.
If the interface does support hardware multicast filtering, then
by not reprogramming the hardware filter in if_delmulti(), we have
to wait until somebody calls if_setmulti(), during which time the
interface is receiving frames for multicast groups in which we are
no longer interested.
FreeBSD/alpha. The most significant item is to change the command
argument to ioctl functions from int to u_long. This change brings us
inline with various other BSD versions. Driver writers may like to
use (__FreeBSD_version == 300003) to detect this change.
The prototype FreeBSD/alpha machdep will follow in a couple of days
time.
Distribute all but the most fundamental malloc types. This time I also
remembered the trick to making things static: Put "static" in front of
them.
A couple of finer points by: bde
Introduce the SIOC[SG]IFGENERIC hooks that can be used to pass an
arbritrary ioctl subcommand into an interface driver. Surprisingly
enough, there was no provision for this already present (except of the
option of abusing SIOC[SG]IFMEDIA for this).
The idea is that an interface driver can establish ioctl subcommands
of its own that can't be meaningfully interpreted by the upper layer
interface ioctl function. Something like this is required to
implement a clean solution of passing down things like CHAP secrets or
PPP options to the /sys/net/if_sppp* files. (Yes, my CHAP is now
finally working with it, but i gotta update my kernel to the new
callout interface before being able to commit _that_.)
Reviewed by: peter [long ago, actually]
by a protocol, to detirmine if an address matches the net this address
is part of. This is needed by protocols for which netmasks
"just don't work", for example appletalk.
Also add the code in appletalk to make use of this new feature.
Thsi fixes one of the longest standing bugs in appletalk.
The inability to talk to machines to which the path is via a router
which is on a different net, but the same netrange, as your interface.
Protocols that do not supply this function (e.g. IP) should not be affected.
This commit includes the following changes:
1) Old-style (pr_usrreq()) protocols are no longer supported, the compatibility
glue for them is deleted, and the kernel will panic on boot if any are compiled
in.
2) Certain protocol entry points are modified to take a process structure,
so they they can easily tell whether or not it is possible to sleep, and
also to access credentials.
3) SS_PRIV is no more, and with it goes the SO_PRIVSTATE setsockopt()
call. Protocols should use the process pointer they are now passed.
4) The PF_LOCAL and PF_ROUTE families have been updated to use the new
style, as has the `raw' skeleton family.
5) PF_LOCAL sockets now obey the process's umask when creating a socket
in the filesystem.
As a result, LINT is now broken. I'm hoping that some enterprising hacker
with a bit more time will either make the broken bits work (should be
easy for netipx) or dike them out.
This will make a number of things easier in the future, as well as (finally!)
avoiding the Id-smashing problem which has plagued developers for so long.
Boy, I'm glad we're not using sup anymore. This update would have been
insane otherwise.
previous hackery involving struct in_ifaddr and arpcom. Get rid of the
abominable multi_kludge. Update all network interfaces to use the
new machanism. Distressingly few Ethernet drivers program the multicast
filter properly (assuming the hardware has one, which it usually does).
