mirror of
https://git.FreeBSD.org/src.git
synced 2024-12-18 10:35:55 +00:00
b27f40c064
support is also included for the ASC38C1600 Ultra160 chipset, but as firmware is not yet available for this chip, it is disabled. Approved by: jkh@FreeBSD.org
136 lines
4.9 KiB
C
136 lines
4.9 KiB
C
/*
|
|
* Exported interface to downloadable microcode for AdvanSys SCSI Adapters
|
|
*
|
|
* $FreeBSD$
|
|
*
|
|
* Obtained from:
|
|
*
|
|
* Copyright (c) 1995-1999 Advanced System Products, Inc.
|
|
* All Rights Reserved.
|
|
*
|
|
* Redistribution and use in source and binary forms, with or without
|
|
* modification, are permitted provided that redistributions of source
|
|
* code retain the above copyright notice and this comment without
|
|
* modification.
|
|
*/
|
|
|
|
#ifndef _ADMCODE_H_
|
|
#define _ADMCODE_H_
|
|
|
|
struct adw_mcode
|
|
{
|
|
const u_int8_t* mcode_buf;
|
|
const u_int32_t mcode_chksum;
|
|
const u_int16_t mcode_size;
|
|
};
|
|
|
|
extern const struct adw_mcode adw_asc3550_mcode_data;
|
|
extern const struct adw_mcode adw_asc38C0800_mcode_data;
|
|
|
|
/*
|
|
* Fixed LRAM locations of microcode operating variables.
|
|
*/
|
|
#define ADW_MC_CODE_BEGIN_ADDR 0x0028 /* microcode start address */
|
|
#define ADW_MC_CODE_END_ADDR 0x002A /* microcode end address */
|
|
#define ADW_MC_CODE_CHK_SUM 0x002C /* microcode code checksum */
|
|
#define ADW_MC_VERSION_DATE 0x0038 /* microcode version */
|
|
#define ADW_MC_VERSION_NUM 0x003A /* microcode number */
|
|
#define ADW_MC_BIOSMEM 0x0040 /* BIOS RISC Memory Start */
|
|
#define ADW_MC_BIOSLEN 0x0050 /* BIOS RISC Memory Length */
|
|
#define ADW_MC_BIOS_SIGNATURE 0x0058 /* BIOS Signature 0x55AA */
|
|
#define ADW_MC_BIOS_VERSION 0x005A /* BIOS Version (2 Bytes) */
|
|
#define ADW_MC_SDTR_SPEED1 0x0090 /* SDTR Speed for TID 0-3 */
|
|
#define ADW_MC_SDTR_SPEED2 0x0092 /* SDTR Speed for TID 4-7 */
|
|
#define ADW_MC_SDTR_SPEED3 0x0094 /* SDTR Speed for TID 8-11 */
|
|
#define ADW_MC_SDTR_SPEED4 0x0096 /* SDTR Speed for TID 12-15 */
|
|
#define ADW_MC_CHIP_TYPE 0x009A
|
|
#define ADW_MC_INTRB_CODE 0x009B
|
|
#define ADW_ASYNC_RDMA_FAILURE 0x01 /* Fatal RDMA failure. */
|
|
#define ADW_ASYNC_SCSI_BUS_RESET_DET 0x02 /* Detected Bus Reset. */
|
|
#define ADW_ASYNC_CARRIER_READY_FAILURE 0x03 /* Carrier Ready failure.*/
|
|
#define ADW_ASYNC_HOST_SCSI_BUS_RESET 0x80 /*
|
|
* Host Initiated
|
|
* SCSI Bus Reset.
|
|
*/
|
|
#define ADW_MC_WDTR_ABLE_BIOS_31 0x0120
|
|
#define ADW_MC_WDTR_ABLE 0x009C
|
|
#define ADW_MC_SDTR_ABLE 0x009E
|
|
#define ADW_MC_TAGQNG_ABLE 0x00A0
|
|
#define ADW_MC_DISC_ENABLE 0x00A2
|
|
#define ADW_MC_IDLE_CMD_STATUS 0x00A4
|
|
#define ADW_MC_IDLE_CMD 0x00A6
|
|
#define ADW_MC_IDLE_CMD_PARAMETER 0x00A8
|
|
#define ADW_MC_DEFAULT_SCSI_CFG0 0x00AC
|
|
#define ADW_MC_DEFAULT_SCSI_CFG1 0x00AE
|
|
#define ADW_MC_DEFAULT_MEM_CFG 0x00B0
|
|
#define ADW_MC_DEFAULT_SEL_MASK 0x00B2
|
|
#define ADW_MC_RISC_NEXT_READY 0x00B4
|
|
#define ADW_MC_RISC_NEXT_DONE 0x00B5
|
|
#define ADW_MC_SDTR_DONE 0x00B6
|
|
#define ADW_MC_NUMBER_OF_QUEUED_CMD 0x00C0
|
|
#define ADW_MC_NUMBER_OF_MAX_CMD 0x00D0
|
|
#define ADW_MC_DEVICE_HSHK_CFG_TABLE 0x0100
|
|
#define ADW_HSHK_CFG_WIDE_XFR 0x8000
|
|
#define ADW_HSHK_CFG_RATE_MASK 0x7F00
|
|
#define ADW_HSHK_CFG_RATE_SHIFT 8
|
|
#define ADW_HSHK_CFG_OFFSET 0x001F
|
|
#define ADW_MC_CONTROL_FLAG 0x0122 /* Microcode control flag. */
|
|
#define ADW_MC_CONTROL_IGN_PERR 0x0001 /* Ignore DMA Parity Errors */
|
|
#define ADW_MC_WDTR_DONE 0x0124
|
|
#define ADW_MC_CAM_MODE_MASK 0x015E /* CAM mode TID bitmask. */
|
|
#define ADW_MC_ICQ 0x0160
|
|
#define ADW_MC_IRQ 0x0164
|
|
|
|
/* ADW_SCSI_REQ_Q 'cntl' field values */
|
|
#define ADW_QC_DATA_CHECK 0x01 /* Require ADW_QC_DATA_OUT set or clear. */
|
|
#define ADW_QC_DATA_OUT 0x02 /* Data out DMA transfer. */
|
|
#define ADW_QC_START_MOTOR 0x04 /* Send auto-start motor before request. */
|
|
#define ADW_QC_NO_OVERRUN 0x08 /* Don't report overrun. */
|
|
#define ADW_QC_FREEZE_TIDQ 0x10 /* Freeze TID queue after request.XXXTBD */
|
|
|
|
#define ADW_QSC_NO_DISC 0x01 /* Don't allow disconnect for request. */
|
|
#define ADW_QSC_NO_TAGMSG 0x02 /* Don't allow tag queuing for request. */
|
|
#define ADW_QSC_NO_SYNC 0x04 /* Don't use Synch. transfer on request.*/
|
|
#define ADW_QSC_NO_WIDE 0x08 /* Don't use Wide transfer on request. */
|
|
#define ADW_QSC_REDO_DTR 0x10 /* Renegotiate WDTR/SDTR before request.*/
|
|
/*
|
|
* Note: If a Tag Message is to be sent and neither ADW_QSC_HEAD_TAG or
|
|
* ADW_QSC_ORDERED_TAG is set, then a Simple Tag Message (0x20) is used.
|
|
*/
|
|
#define ADW_QSC_HEAD_TAG 0x40 /* Use Head Tag Message (0x21). */
|
|
#define ADW_QSC_ORDERED_TAG 0x80 /* Use Ordered Tag Message (0x22). */
|
|
|
|
struct adw_carrier
|
|
{
|
|
u_int32_t carr_offset; /* Carrier byte offset into our array */
|
|
u_int32_t carr_ba; /* Carrier Bus Address */
|
|
u_int32_t areq_ba; /* SCSI Req Queue Bus Address */
|
|
u_int32_t next_ba;
|
|
#define ADW_RQ_DONE 0x00000001
|
|
#define ADW_CQ_STOPPER 0x00000000
|
|
#define ADW_NEXT_BA_MASK 0xFFFFFFF0
|
|
};
|
|
|
|
/*
|
|
* Microcode idle loop commands
|
|
*/
|
|
typedef enum {
|
|
ADW_IDLE_CMD_COMPLETED = 0x0000,
|
|
ADW_IDLE_CMD_STOP_CHIP = 0x0001,
|
|
ADW_IDLE_CMD_STOP_CHIP_SEND_INT = 0x0002,
|
|
ADW_IDLE_CMD_SEND_INT = 0x0004,
|
|
ADW_IDLE_CMD_ABORT = 0x0008,
|
|
ADW_IDLE_CMD_DEVICE_RESET = 0x0010,
|
|
ADW_IDLE_CMD_SCSI_RESET_START = 0x0020,
|
|
ADW_IDLE_CMD_SCSI_RESET_END = 0x0040,
|
|
ADW_IDLE_CMD_SCSIREQ = 0x0080
|
|
} adw_idle_cmd_t;
|
|
|
|
typedef enum {
|
|
ADW_IDLE_CMD_FAILURE = 0x0000,
|
|
ADW_IDLE_CMD_SUCCESS = 0x0001
|
|
} adw_idle_cmd_status_t;
|
|
|
|
|
|
#endif /* _ADMCODE_H_ */
|