Pyun YongHyeon 5f14ee2363 Split common TX/RX descriptor DMA tag to TX and RX DMA tags ... respectively and fix all bus_dma(9) issues seen when bounce buffers are used. o Setup frame handling had no bus_dmamap_sync(9) which prevented driver from configuring RX filter. Add missing bus_dmamap_sync(9) in both dc_setfilt_21143()/dc_setfilt_xircom() and dc_txeof(). o Use bus_addr_t for DMA segment instead of using u_int32_t. o Introduce dc_dma_alloc()/dc_dma_free() functions to allocate/free DMA'able memory. o Create two DMA descriptor list for each TX/RX lists. This change will minimize the size of bounce buffers that would be used in each TX/RX path. Previously driver had to copy both TX/RX lists when bounce buffer is active. o 21143 data sheet says descriptor list requires 4 bytes alignment. Remove PAGE_SIZE alignment restriction and use sizeof(struct dc_dec). o Setup frame requires 4 bytes alignment. Remove PAGE_SIZE alignment restriction and use sizeof(struct dc_dec). o Add missing DMA map unload for both setup frame and TX/RX descriptor list. o Overhaul RX handling logic such that make driver always allocate new RX buffer with dc_newbuf(). Previously driver allowed to copy received frame with m_devget(9) after passing the descriptor ownership to controller. This can lead to passing wrong frame to upper stack. o Introduce dc_discard_rxbuf() which will discard received frame and reuse loaded DMA map and RX mbuf. o Correct several wrong bus_dmamap_sync(9) usage in dc_rxeof and dc_txeof. The TX/RX descriptor lists are updated by both driver and HW so READ/WRITE semantics should be used. o If driver failed to allocate new RX buffer, update if_iqdrops counter instead of if_ierrors since driver received the frame without errors. o Make sure to unload loaded setup frame DMA map in dc_txeof and clear the mark of setup frame of the TX descriptor in dc_txeof(). o Add check for possible TX descriptor overruns in dc_encap() and move check for free buffer to caller, dc_start_locked(). o Swap the loaded DMA map and the last DMA map for multi-segmented frames. Since dc_txeof() assumes the last descriptor of the frame has the DMA map, driver should swap the first and the last DMA map in dc_encap(). Previously driver tried to unload not-yet-loaded DMA map such that the loaded DMA map was not unloaded at all for multi-segmented frames. o Rewrite DC_RXDESC/DC_TXDESC macro to simpler one. o Remove definition of ETHER_ALIGN, it's already defined in ethernet.h. With this changes, dc(4) works with bounce buffers and it shall also fix issues which might have shown in PAE environments. Tested by: marius		2011-02-19 02:47:10 +00:00
..
dcphy.c	- Even after masking the media with IFM_GMASK the result may have bits	2011-01-14 20:26:59 +00:00
if_dc.c	Split common TX/RX descriptor DMA tag to TX and RX DMA tags	2011-02-19 02:47:10 +00:00
if_dcreg.h	Split common TX/RX descriptor DMA tag to TX and RX DMA tags	2011-02-19 02:47:10 +00:00
pnphy.c	- Even after masking the media with IFM_GMASK the result may have bits	2011-01-14 20:26:59 +00:00