mirror of
https://git.FreeBSD.org/src.git
synced 2024-12-17 10:26:15 +00:00
a4cd5630b0
non-i386, non-unix, and generatable files have been trimmed, but can easily be added in later if needed. gcc-2.7.2.1 will follow shortly, it's a very small delta to this and it's handy to have both available for reference for such little cost. The freebsd-specific changes will then be committed, and once the dust has settled, the bmakefiles will be committed to use this code.
118 lines
4.8 KiB
Plaintext
118 lines
4.8 KiB
Plaintext
3. When find_reloads is used to count number of spills needed
|
|
it does not take into account the fact that a reload may
|
|
turn out to be a dummy.
|
|
|
|
I'm not sure this really happens any more. Doesn't it find
|
|
all the dummies on both passes?
|
|
|
|
10. movl a3@,a0
|
|
movl a3@(16),a1
|
|
clrb a0@(a1:l)
|
|
is generated and may be worse than
|
|
movl a3@,a0
|
|
addl a3@(16),a0
|
|
clrb a0@
|
|
If ordering of operands is improved, many more
|
|
such cases will be generated from typical array accesses.
|
|
|
|
38. Hack expand_mult so that if there is no same-modes multiply
|
|
it will use a widening multiply and then truncate rather than
|
|
calling the library.
|
|
|
|
39. Hack expanding of division to notice cases for
|
|
long -> short division.
|
|
|
|
40. Represent divide insns as (DIV:SI ...) followed by
|
|
a separate lowpart extract. Represent remainder insns as DIV:SI
|
|
followed by a separate highpart extract. Then cse can work on
|
|
the DIV:SI part. Problem is, this may not be desirable on machines
|
|
where computing the quotient alone does not necessarily give
|
|
a remainder--such as the 68020 for long operands.
|
|
|
|
52. Reloading can look at how reload_contents got set up.
|
|
If it was copied from a register, just reload from that register.
|
|
Otherwise, perhaps can change the previous insn to move the
|
|
data via the reload reg, thus avoiding one memory ref.
|
|
|
|
63. Potential problem in cc_status.value2, if it ever activates itself
|
|
after a two-address subtraction (which currently cannot happen).
|
|
It is supposed to compare the current value of the destination
|
|
but eliminating it would use the results of the subtraction, equivalent
|
|
to comparing the previous value of the destination.
|
|
|
|
65. Should loops that neither start nor end with a break
|
|
be rearranged to end with the last break?
|
|
|
|
69. Define the floating point converting arithmetic instructions
|
|
for the 68881.
|
|
|
|
74. Combine loop opt with cse opt in one pass. Do cse on each loop,
|
|
then loop opt on that loop, and go from innermost loops outward.
|
|
Make loop invariants available for cse at end of loop.
|
|
|
|
85. pea can force a value to be reloaded into an areg
|
|
which can make it worse than separate adding and pushing.
|
|
This can only happen for adding something within addql range
|
|
and it only loses if the qty becomes dead at that point
|
|
so it can be added to with no copying.
|
|
|
|
93. If a pseudo doesn't get a hard reg everywhere,
|
|
can it get one during a loop?
|
|
|
|
96. Can do SImode bitfield insns without reloading, but must
|
|
alter the operands in special ways.
|
|
|
|
99. final could check loop-entry branches to see if they
|
|
screw up deletion of a test instruction. If they do,
|
|
can put another test instruction before the branch and
|
|
make it conditional and redirect it.
|
|
|
|
106. Aliasing may be impossible if data types of refs differ
|
|
and data type of containing objects also differ.
|
|
(But check this wrt unions.)
|
|
|
|
108. Can speed up flow analysis by making a table saying which
|
|
register is set and which registers are used by each instruction that
|
|
only sets one register and only uses two. This way avoid the tree
|
|
walk for such instructions (most instructions).
|
|
|
|
109. It is desirable to avoid converting INDEX to SImode if a
|
|
narrower mode suffices, as HImode does on the 68000.
|
|
How can this be done?
|
|
|
|
110. Possible special combination pattern:
|
|
If the two operands to a comparison die there and both come from insns
|
|
that are identical except for replacing one operand with the other,
|
|
throw away those insns. Ok if insns being discarded are known 1 to 1.
|
|
An andl #1 after a seq is 1 to 1, but how should compiler know that?
|
|
|
|
112. Can convert float to unsigned int by subtracting a constant,
|
|
converting to signed int, and changing the sign bit.
|
|
|
|
117. Any number of slow zero-extensions in one loop, that have
|
|
their clr insns moved out of the loop, can share one register
|
|
if their original life spans are disjoint.
|
|
But it may be hard to be sure of this since
|
|
the life span data that regscan produces may be hard to interpret
|
|
validly or may be incorrect after cse.
|
|
|
|
118. In cse, when a bfext insn refers to a register, if the field
|
|
corresponds to a halfword or a byte and the register is equivalent
|
|
to a memory location, it would be possible to detect this and
|
|
replace it with a simple memory reference.
|
|
|
|
121. Insns that store two values cannot be moved out of loops.
|
|
The code in scan_loop doesn't even try to deal with them.
|
|
|
|
122. When insn-output.c turns a bit-test into a sign-test,
|
|
it should see whether the cc is already set up with that sign.
|
|
|
|
123. When a conditional expression is used as a function arg, it would
|
|
be faster (and in some cases shorter) to push each alternative rather
|
|
than compute in a register and push that. This would require
|
|
being able to specify "push this" as a target for expand_expr.
|
|
|
|
124. On the 386, bad code results from foo (bar ()) when bar
|
|
returns a double, because the pseudo used fails to get preferenced
|
|
into an fp reg because of the distinction between regs 8 and 9.
|