Peter Wemm 931e989797 Always leave SP_DCEN on (monitor DCD). Otherwise the firmware *really* ... does ignore DCD. Even TIOCMGET cannot read DCD as the firmware doesn't report it. This has pretty interesting effects for ppp(8) which runs in clocal mode and polls carrier (!). (Specialix's linux driver does this too) Also update the firmware to 3.0.6 for the SX cards, as apparently there was a problem with floating (disconnected) DCD pins causing stray carrier transitions, especially at port open time. It seems to work here, and carrier loss is detected nearly immediately rather than having to wait for a LQR timeout (a few minutes) before ppp(8) gives up. DCD problem noted by: nsayer		2000-01-25 16:45:54 +00:00
..
si2_z280.c	A bit more newbusification of si. This still isn't quite finished.	2000-01-24 07:24:02 +00:00
si3_t225.c	Always leave SP_DCEN on (monitor DCD). Otherwise the firmware *really*	2000-01-25 16:45:54 +00:00
si_eisa.c	A bit more newbusification of si. This still isn't quite finished.	2000-01-24 07:24:02 +00:00
si_isa.c	A bit more newbusification of si. This still isn't quite finished.	2000-01-24 07:24:02 +00:00
si_pci.c	Ack! I totally botched the pci probe routine which resulted in it trying	2000-01-24 08:11:10 +00:00
si.c	Always leave SP_DCEN on (monitor DCD). Otherwise the firmware *really*	2000-01-25 16:45:54 +00:00
si.h	A bit more newbusification of si. This still isn't quite finished.	2000-01-24 07:24:02 +00:00
sireg.h	Initial attempt at newbusification of the specialix si/xio/sx driver.	2000-01-23 22:51:49 +00:00
sivar.h	A bit more newbusification of si. This still isn't quite finished.	2000-01-24 07:24:02 +00:00