Kirk McKusick fb14e73cb4 Normally when an attempt is made to mount a UFS/FFS filesystem whose ... superblock has a check-hash error, an error message noting the superblock check-hash failure is printed and the mount fails. The administrator then runs fsck to repair the filesystem and when successful, the filesystem can once again be mounted. This approach fails if the filesystem in question is a root filesystem from which you are trying to boot. Here, the loader fails when trying to access the filesystem to get the kernel to boot. So it is necessary to allow the loader to ignore the superblock check-hash error and make a best effort to read the kernel. The filesystem may be suffiently corrupted that the read attempt fails, but there is no harm in trying since the loader makes no attempt to write to the filesystem. Once the kernel is loaded and starts to run, it attempts to mount its root filesystem. Once again, failure means that it breaks to its prompt to ask where to get its root filesystem. Unless you have an alternate root filesystem, you are stuck. Since the root filesystem is initially mounted read-only, it is safe to make an attempt to mount the root filesystem with the failed superblock check-hash. Thus, when asked to mount a root filesystem with a failed superblock check-hash, the kernel prints a warning message that the root filesystem superblock check-hash needs repair, but notes that it is ignoring the error and proceeding. It does mark the filesystem as needing an fsck which prevents it from being enabled for writing until fsck has been run on it. The net effect is that the reboot fails to single user, but at least at that point the administrator has the tools at hand to fix the problem. Reported by: Rick Macklem (rmacklem@) Discussed with: Warner Losh (imp@) Sponsored by: Netflix		2018-12-06 00:09:39 +00:00
..
tests
debug.c
debug.h
growfs.8
growfs.c	Normally when an attempt is made to mount a UFS/FFS filesystem whose	2018-12-06 00:09:39 +00:00
Makefile
Makefile.depend