mirror of
https://git.FreeBSD.org/src.git
synced 2024-12-21 11:13:30 +00:00
eb12447d83
This is an AR7240 based device with an AR9285 on-board. I've tested the initial boot and wifi support; however at the moment the ethernet switch driver doesn't seem to be picking up carrier on the active ethernet port. Basic flood pinging works however, so I think we're on the right track. Thank you to Adrian Woodley <adrian@diskworld.com.au> for purchasing me one of these devices to bootstrap FreeBSD-HEAD on.
45 lines
1.1 KiB
Plaintext
45 lines
1.1 KiB
Plaintext
#
|
|
# Specific board setup for the Engenius ENH-200 802.11bgn mesh node.
|
|
#
|
|
# The Engenius ENH-200 has the following hardware:
|
|
#
|
|
# + AR7240 CPU SoC
|
|
# + AR9285 Wifi
|
|
# + Integrated switch
|
|
# + 8MB flash
|
|
# + 32MB RAM
|
|
# + uboot environment
|
|
|
|
# $FreeBSD$
|
|
|
|
include "AR724X_BASE"
|
|
ident "ENH200"
|
|
hints "ENH200.hints"
|
|
|
|
options AR71XX_REALMEM=32*1024*1024
|
|
|
|
options AR71XX_ENV_UBOOT
|
|
|
|
# For DOS - enable if required
|
|
options MSDOSFS
|
|
|
|
# uncompress - to boot read-only lzma natively from flash
|
|
device geom_uncompress
|
|
options GEOM_UNCOMPRESS
|
|
options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
|
|
|
|
# Used for the static uboot partition map
|
|
device geom_map
|
|
|
|
# Options needed for the EEPROM based calibration/PCI configuration data.
|
|
options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
|
|
options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
|
|
device firmware # Used by the above
|
|
|
|
# Options required for miiproxy and mdiobus
|
|
options ARGE_MDIO # Export an MDIO bus separate from arge
|
|
device miiproxy # MDIO bus <-> MII PHY rendezvous
|
|
|
|
device etherswitch
|
|
device arswitch
|