mirror of
https://git.FreeBSD.org/src.git
synced 2024-12-29 12:03:03 +00:00
fc35a81b09
- deprecate routes#N, as it is hard to keep consistency with rtprefixN. accept any number of "rtprefix", "rtrefix0", ..., "rtprefix99". - deprecate "addrs#N", as it is difficult for users to keep consistency with "addrN". accept 100 prefix info in maximum - like "addr", "addr0" ... "addr99". WARNS=2 clean on netbsd. old configuration file should work just fine. behavior change: previously, we rejected "addrN" if there's "addr", and we rejected "addr" if there is "addrN". now we accept both without problem. - when an advertised prefix configured from the kernel has been added or invalidated, notice the change in a short delay. - when invalidating a prefix, do not bark even if there is inconsistency about prefix lifetimes. - wrap more specific route info code into ROUTEINFO. Obtained from: KAME MFC after: 1 week
22 lines
903 B
Plaintext
22 lines
903 B
Plaintext
# $FreeBSD$
|
|
# $KAME: rtadvd.conf,v 1.13 2003/06/25 03:45:21 itojun Exp $
|
|
#
|
|
# Note: All of the following parameters have default values defined
|
|
# in specifications, and hence you usually do not have to set them
|
|
# by hand unless you need special non-default values.
|
|
#
|
|
# You even do not need to create the configuration file. rtadvd
|
|
# would usually work well without a configuration file.
|
|
# See also: rtadvd(8)
|
|
|
|
# per-interface definitions.
|
|
# Mainly IPv6 prefixes are configured in this part. However, rtadvd
|
|
# automatically learns appropriate prefixes from the kernel's routing
|
|
# table, and advertises the prefixes, so you don't have to configure
|
|
# this part, either.
|
|
# If you don't want the automatic advertisement, (uncomment and) configure
|
|
# this part by hand, and then invoke rtadvd with the -s option.
|
|
|
|
#ef0:\
|
|
# :addr="3ffe:501:ffff:1000::":prefixlen#64:
|