Bill Paul edd033746c Remove the dual-address cycle stuff. DAC is used to allow a bus master ... device to access 64-bit addresses from a 32-bit PCI bus. While the RealTek manual says you can set this bit and the chip will perform DAC only if you give it a DMA address with any of the upper 32 bits set, this appears not to be the case. If I turn on the DAC bit, the chip sets the 'system error' bit in the status register when I to do a DMA on my Athlon test box with 32-bit PCI bus (VIA chipset) even though I only have 128MB of physical memory, and thus can never give the chip a 64-bit address. Obviously, I can't just set it and forget it, so until I figure out the right rule for when it's safe/necessary to enable it, keep it turned off.		2003-09-20 21:18:27 +00:00
..
if_re.c	Remove the dual-address cycle stuff. DAC is used to allow a bus master	2003-09-20 21:18:27 +00:00