- Shared lib version and PORTREVISION bumb for all affected ports.
While I'm here:
- Remove USE_MESA knob where it was (35 ports).
It marked as depricated for 2 years.
PR: ports/90247
Submitted by: Ermal Lu?i <eri--@albabsd.org>
When I ported this I added amd64 to give the "benefit of
doubt" however I had the chance top test it but it doesn't
work, it coredumps.
PR: ports/91188
Submitted by: Pedro F. Giffuni <giffunip@asme.org>
Another version upgrade. The amd64 problem has been fixed,
both as a patch here and in the HEAD of the sf.net repository.
This has only been tested on 6.0/ia32 and 6.0/amd64, my 7
box is down and I don't have 4 or 5 anymore. :/
PR: ports/91037
Submitted by: Erik Greenwald <erik@smluc.org>
GPL Cver is a full 1995 P1364 Verilog standard HDL simulator.
It also implements some of the 2001 P1364 standard features
including all three PLI interfaces (tf_, acc_ and vpi_) as
defined in the 2001 Language Reference Manual (LRM).
Verilog is the name for both a language for describing
electronic hardware called a hardware description language
(HDL) and the name of the program that simulates HDL circuit
descriptions to verify that described circuits will function
correctly when the are constructed. Verilog is used only
for describing digital logic circuits. Other HDLs such as
Spice are used for describing analog circuits. There is an
IEEE standard named P1364 that standardizes the Verilog HDL
and the behavior of Verilog simulators. Verilog is officially
defined in the IEEE P1364 Language Reference Manual (LRM)
that can be purchased from IEEE. There are many good books
for learning that teach the Verilog HDL and/or that teach
digital circuit design using Verilog.
WWW: http://www.pragmatic-c.com/gpl-cver/
PR: ports/80968
Submitted by: Ying-Chieh Liao <ijliao@csie.nctu.edu.tw>
- Update to 27
- Use a static pkg-plist
- Pass maintainership to submitter
PR: ports/90818
Submitted by: Soeren Straarup <xride@x12.dk>
Submitted by: pointyhat (kris)
Pointy hat to: garga
diagrams and printed circuit board artwork.
Kicad is a set of four softwares and a project manager:
* Eeschema: Schematic entry.
* Pcbnew: Board editor.
* Gerbview: GERBER viewer (photoplotter documents).
* Cvpcb: footprint selector for components used in the circuit design.
* Kicad: project manager.
in bsd.autotools.mk essentially makes this a no-op given that all the
old variables set a USE_AUTOTOOLS_COMPAT variable, which is parsed in
exactly the same way as USE_AUTOTOOLS itself.
Moreover, USE_AUTOTOOLS has already been extensively tested by the GNOME
team -- all GNOME 2.12.x ports use it.
Preliminary documentation can be found at:
http://people.FreeBSD.org/~ade/autotools.txt
which is in the process of being SGMLized before introduction into the
Porters Handbook.
Light blue touch-paper. Run.
