- add an option for the output device in the hope that this can
be made non-blocking at some stage.
- define an alias for the disk device, required by dev/ofw/ofw_disk.c
- shift iobus to 0x9000000 so as not to clash with the OpenFirmware
entry point of 0x8000400 when address decoding.
- down-tone comments about the disk dev config :-)
using the direct-mapping of physmem to force PTE data structures
to be physically addressable so the interrupt-time real-mode
DSI trap handler could perform PTE spills. However, the memory
may have been > 256Mb, which would have caused a BAT spill and
double-interrupt.
The new trap code no longer handles PTE spills, so the requirement
that these pages be direct-mapped no longer applies. The irony is
UMA_MD_SMALL_ALLOC will return direct mappings for these structs :-)
- remove unused 601 and tlb exception code
- remove interrupt-time PTE spill code. The pmap code
will now take care of pinning kernel PTEs, and there
are no longer issues about physical mapping of PTE
data structures
- All segment registers are switched on kernel entry/exit,
allowing the kernel to have more virtual space and for
user virtual space to extend to 4G.
- The temporary register save area has been shifted from
unused exception vector space to the per-cpu data area.
This allows interrupts to be delivered to multiple CPUs
- ISI traps no longer spill to BAT tables. It is assumed
that all of kernel instruction memory is pinned.
- shift from 'ldmw/stmw' instructions to individual register
loads/stores when saving context. All PPC manuals indicate
this should be much faster.
- use '%r' for register names throughout.
TODO: need to test if DSI traps were the result of kernel stack
guard-page hits.
Reworked from: NetBSD
for direct-mapped addresses. Assume that any address less than KVA
is one of these and return it. Also assert that an address is KVA
does have a valid mapping - callers of pmap_kextract don't check
the return value, since they assume that they have a valid virtual
address.
addressing of memory. Makes a substantial improvement for apps that
stress the limited amount of KVM on PPC (e.g. untarring the ports tree).
uma_machdep.c stolen from amd64/ia64.
the MacIO chip and PSIM's IOBus. Bus-specific drivers should
use the identify method to attach themselves to nexus so
interrupt can be allocated before the h/w is probed. The
'early attach' routine in openpic is used for this stage
of boot. When h/w is probed, the openpic can be attached
properly. It will enable interrupts allocated prior to
this.
and add_child entry point to allow devices to use the identify
method to add themselves if need be (e.g. openpic, syscons).
Export interrupt-controller-add routine for extern int cntlr drivers.
Eliminate recursive OFW device-tree walk and only iterate the
top-level ala sparc64. Allow child devices to set the device
type with write_ivars.
Step 1 of many in removing the hard-dependency on OpenFirmware.
is useless for threaded programs, multiple threads can not share same
stack.
The alternative signal stack is private for thread, no lock is needed,
the orignal P_ALTSTACK is now moved into td_pflags and renamed to
TDP_ALTSTACK.
For single thread or Linux clone() based threaded program, there is no
semantic changed, because those programs only have one kernel thread
in every process.
Reviewed by: deischen, dfr
correctly, resulting in the dreaded "vm_pageout_flush: partially
invalid page" panic. The caching issue will be revisited in the
future, but opt for safety over performance in the meantime.
Tested by: gallatin
- OpenFirmware returns overlapping memory regions. Use a simple
brute force algorithm to merge these into non-overlapping
regions. This fixes bugs in reporting of available memory
and also prevents pages from being added twice in the VM system.
reboot, as calling OF_exit() just hangs a mac.
FreeBSD on my G4 800Mhz mac behaves identically to OSX for halt
and reboot now.
Reviewed by: grehan (who also supplied the concept and sample code)
very early (SI_SUB_TUNABLES - 1) and is responsible for setting mp_maxid.
cpu_mp_probe() is now called at SI_SUB_CPU and determines if SMP is
actually present and sets mp_ncpus and all_cpus. Splitting these up
allows an architecture to probe CPUs later than SI_SUB_TUNABLES by just
setting mp_maxid to MAXCPU in cpu_mp_setmaxid(). This could allow the
CPU probing code to live in a module, for example, since modules
sysinit's in modules cannot be invoked prior to SI_SUB_KLD. This is
needed to re-enable the ACPI module on i386.
- For the alpha SMP probing code, use LOCATE_PCS() instead of duplicating
its contents in a few places. Also, add a smp_cpu_enabled() function
to avoid duplicating some code. There is room for further code
reduction later since much of this code is also present in cpu_mp_start().
- All archs besides i386 still set mp_maxid to the same values they set it
to before this change. i386 now sets mp_maxid to MAXCPU.
Tested on: alpha, amd64, i386, ia64, sparc64
Approved by: re (scottl)
physical mapping.
- Move the sf_buf API to its own header file; make struct sf_buf's
definition machine dependent. In this commit, we remove an
unnecessary field from struct sf_buf on the alpha, amd64, and ia64.
Ultimately, we may eliminate struct sf_buf on those architecures
except as an opaque pointer that references a vm page.
Since all callers either passed 0 or 1 for clear_ret, define bit 0 in
the flags for use as clear_ret. Reserve bits 1, 2 and 3 for use by MI
code for possible (but unlikely) future use. The remaining bits are for
use by MD code.
This change is triggered by a need on ia64 to have another knob for
get_mcontext().
A small helper function pmap_is_prefaultable() is added. This function
encapsulate the few lines of pmap_prefault() that actually vary from
machine to machine. Note: pmap_is_prefaultable() and pmap_mincore() have
much in common. Going forward, it's worth considering their merger.
systems where the data/stack/etc limits are too big for a 32 bit process.
Move the 5 or so identical instances of ELF_RTLD_ADDR() into imgact_elf.c.
Supply an ia32_fixlimits function. Export the clip/default values to
sysctl under the compat.ia32 heirarchy.
Have mmap(0, ...) respect the current p->p_limits[RLIMIT_DATA].rlim_max
value rather than the sysctl tweakable variable. This allows mmap to
place mappings at sensible locations when limits have been reduced.
Have the imgact_elf.c ld-elf.so.1 placement algorithm use the same
method as mmap(0, ...) now does.
Note that we cannot remove all references to the sysctl tweakable
maxdsiz etc variables because /etc/login.conf specifies a datasize
of 'unlimited'. And that causes exec etc to fail since it can no
longer find space to mmap things.
