It fixes driver attach issue to a new firmware which reports a new
port-modes.
Reviewed by: gnn
Submitted by: Tom Millington <tmillington at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D8203
The _correct_ way to identify the supported checksum offloading and
TSO parameters is to query OID_TCP_OFFLOAD_HARDWARE_CAPABILITIES.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8088
- Fix range check
- Due to checking found value in for(;;) condition irq after loop was
always + 1 from actually found slot and wrong entry was marked as
used which lead to returning slot 0 for all requests.
r301059 accidently introduced a subtle change for point to point interfaces
where an extra space is inserted before the netmask. This can cause issues
for scripts that parse ifconfig output.
Submitted by: Kevin Bowling <kevin.bowling@kev009.com>
Reviewed by: hiren
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D8199
ieee80211_tx_complete()
This change allows to pass packet length to rate control modules and
fixes IFCOUNTER_OBYTES calculation.
Tested with Intel 3945BG, STA mode.
- Add multitouch support (protocol B)
- Report physical size of the screen
- Switch from using busy loop to callbacks
- Enable callbacks only when there is active listener on /dev/input/eventX
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
Automaticaly release (send ABS_MT_TRACKING_ID = -1) MT-slots
that has not been listed in current MT protocol type B report.
Slot is counted as listed if corresponding ABS_MT_SLOT event
has been sent regardless of other MT events.
Events are sent on SYN_REPORT event.
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
Add new API call: evdev_register_mtx which takes lock argument that
should be used instead of internal one for evdev locking. Useful for
cases if evdev_push_event() is always called with driver's lock taken
and reduces amount of lock aquisitions. This allows to avoid LOR
between ev_open/ev_close invocations and evdev_push_event() Such LOR
can happen when ev_open/ev_close methods acquire driver lock and
evdev_push_event() is called with this lock taken.
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
Don't warn about valid time zone abbreviations. POSIX
through 2000 says that an abbreviation cannot start with ':', and
cannot contain ',', '-', '+', NUL, or a digit. POSIX from 2001
on changes this rule to say that an abbreviation can contain only
'-', '+', and alphanumeric characters from the portable character
set in the current locale. To be portable to both sets of rules,
an abbreviation must therefore use only ASCII letters." Adapted
from tzcode2015f.
This is needed to be able to update tzdata to a newer version
MFC after: 3 days
Per Austin group issue #884, always set IFS to $' \t\n'. As before, IFS will
be exported iff it was in the environment.
Most shells (e.g. bash, ksh93 and mksh) already did this. This change
improves predictability, in that scripts can simply rely on the default
value.
However, the effect on security is little, since applications should not be
calling the shell with attacker-controlled environment variable names in the
first place and other security-sensitive variables such as PATH should be
and are imported by the shell.
When using a new sh with an old (before 10.2) libc wordexp(), IFS is no
longer passed on. Otherwise, wordexp() continues to pass along IFS from the
environment per its documentation.
Discussed with: pfg
Relnotes: yes
Don't call pmap_kextract() multiple times, it wastes CPU cycles, which in a high
performance environment can be very expensive.
Inline XX_FindTracker() to allow more optimizations as well.
There are a variety of more interesting RX statistics that we should
keep track of but we don't. This is a starting point for adding more
information.
Specifically:
* now the RX rate information and some of the packet status is
passed up;
* The 32 bit or 64 bit TSF is passed up;
* the PHY mode is passed up;
* the "I'm decap'ed AMSDU!" state is passed up;
* number of RX chains is bumped to 4.
This is all mostly a placeholder for getting the data into the RX status
before we pass it up to net80211 - unfortunately we don't yet enforce
that drivers provide it, nor do we pass the provided info back up the
stack so anyone can use the data.
We're going to need to use some of this data moving forward.
Notably, now that some hardware can do AMSDU decap for us (the intel iwm
driver can do it when we flip it on; the ath10k port I'm doing does
it for us) then we need to pass it up through the stack so the duplicate
RX sequence numbers and crypto/IV details don't cause the packet to
be dropped and/or counted against a replay counter.
It's also the beginning of being able to do more interesting node
accounting in net80211. Specifically, once drivers start populating
per-packet rate information, AMPDU information, timestamps, etc,
we can start providing histograms of rate-versus-RSSI, account
for receive time spent per node and other such interesting things.
(Note: I'm also hoping to include ranging and RTT information for
future chipset support; and it's likely going to include it in
this kind of fashion.)
This change extends the nd6 lock to protect the ND prefix list as well
as the list of advertising routers associated with each prefix. To handle
cases where the nd6 lock must be dropped while iterating over either the
prefix or default router lists, a generation counter is used to track
modifications to the lists. Additionally, a new mutex is used to serialize
prefix on-link/off-link transitions. This mutex must be acquired before
the nd6 lock and is held while updating the routing table in
nd6_prefix_onlink() and nd6_prefix_offlink().
Reviewed by: ae, tuexen (SCTP bits)
Tested by: Jason Wolfe <jason@llnw.com>,
Larry Rosenman <ler@lerctr.org>
MFC after: 2 months
Differential Revision: https://reviews.freebsd.org/D8125
when we are exiting anyway.
Add NULL checks for all malloc and strdup returns.
Reviewed by: gnn
Approved by: sjg (mentor)
Obtained from: Juniper Networks, Inc.
Differential Revision: https://reviews.freebsd.org/D8002
This change is equivalent to the approach committed in r306417, but if
sed has a bug it could be exploited by the untrusted tar file. Instead,
generate the expected tar content and compare that with find's output.
convert the expected hash list to the expected tar content filesystem
layout, and compare that with find's output.
Submitted by: cperciva (in review D8052)
Reviewed by: oshogbo
MFC after: 2 weeks
R_AARCH64_RELATIVE relocation found on arm64. It would try to add the
contents of the memory location being relocated to the base address and
the relocation addend. This worked when the contents was zero, however
this now seems to be set to the value of the addend so we add this twice.
Fix this by just setting the memory to the computed value.
Reviewed by: emaste
MFC after: 1 week
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D8177
