modules to rip out the available sysctls. It will then produce a manual
page which may be installed with 'make install'. Currently typing 'make'
in the directory uses the default /boot/kernel files. To use a specific
directory, run sysdoc -k [location].
- Use fesetround() instead of fpsetround(), and add tests for
various rounding modes.
- Test that all NaNs generated are quiet.
Some of these tests won't pass until problems in vendor sources
(gdtoa and gcc) are fixed and new versions imported, but I
want to get these changes into the tree before I accidentally
blow them away again. :-(
tests. (Buy 10, get one free!) The separate categories were
already there; they just weren't labeled.
- Use fesetround() instead of fpsetround(), since the former is
standard and implemented on all supported architectures. Add
tests for each rounding mode.
- Add additional tests for subnormals.
Some of these tests won't pass until problems in vendor sources
(gdtoa and gcc) are fixed and new versions imported, but I
want to get these changes into the tree before I accidentally
blow them away.
is particularly useful when VESA is available (either `options VESA'
or load the vesa module), as BIOSes in some notebooks may correctly
save and restore LCD panel settings using VESA in cases where calling
the video BIOS POST is not effective. On some systems it may also
be necessary to set the hw.acpi.reset_video sysctl to 0.
While version 4 entries are architecture-independent, we
also store old (version 3) entries in native byte order.
Also, the hash itself is created in a native byte order.
With this change, pwd_mkdb(8) can be used to cross-build
*pwd.db files for another architecture.
Tested on: i386, amd64, alpha, sparc64
Also save the DAC state, increase the maximum save state size from
4k to 8k, and refuse to save the VESA state if the BIOS reports it
is larger than the maximum size we can handle.
It doesn't appear that anything currently uses this code, but it
turns out to be capable of restoring some notebook displays to a
working state after a suspend-resume cycle.
if either INVARIANTS or INVARIANT_SUPPORT is defined so that kernel modules
that want to use mtx_assert() only need to define INVARIANTS.
MFC after: 1 week
an else clause. Move the assignment to the lengthPtr down to
just before the return statements.
Patch: 7.81
Submitted by: Max Okumoto <okumoto@ucsd.edu>
The former tip used `col -bx', which would not only discard
CR's, but also expand TAB's and remove BS'en. This effect is
not always wanted.
MFC after: 1 week
attempting to change the BPF filter on a BPF descriptor at the same
time: retrieve the old filter pointer under the same locked region
as setting the new pointer.
MFC after: 3 days
"+" to the port number, disable option negotiation and allow
transferring of data with high bit set.
OKed by: markm (maintainer)
PR: 52032
Submitted by: Valentin Nechayev <netch maybe-at netch stop kiev stop ua>
MFC After: 2 weeks
- Use our loop DLT type, not OpenBSD. [1]
- The fields that are converted to network byte order are not 32-bit
fields but 16-bit fields, so htons should be used in htonl. [1]
- Secondly, ip_input changes ip->ip_len into its value without
the ip-header length. So, restore the length to make bpf happy. [1]
- Use bpf_mtap2(), use temporary af1, since bpf_mtap2 doesn't
understand uint8_t af identifier.
Submitted by: Frank Volf [1]
