this eliminates some problems of locking, e.g, a thread lock is needed
but can not be used at that time. Only the process lock is needed now
for new field.
o better quality of the movement smoothing
o more features such as tap-hold and virtual scrolling
Support must still be enabled with this line in your /boot/loader.conf:
hw.psm.synaptics_support="1"
The following sysctls were removed:
hw.psm.synaptics.low_speed_threshold
hw.psm.synaptics.min_movement
hw.psm.synaptics.squelch_level
An overview of this new driver and a short documentation about the added
sysctls is available on the wiki:
http://wiki.freebsd.org/SynapticsTouchpad
simplifies certain device attachments (Kauai ATA, for instance), and makes
possible others on new hardware.
On G5 systems, there are several otherwise standard PCI devices
(Serverworks SATA) that will not allow their interrupt properties to be
written, so this information must be supplied directly from Open Firmware.
Obtained from: sparc64
This uses the common U-Boot support lib (sys/boot/uboot, already used on
FreeBSD/powerpc), and assumes the underlying firmware has the modern API for
stand-alone apps enabled in the config (CONFIG_API).
Only netbooting is supported at the moment.
Obtained from: Marvell, Semihalf
FreeBSD 8-CURRENT was tested and run successfully on the following eval
boards and devices :
* DB-88F5182, DB-88F5281 (Orion based)
* DB-88F6281, RD-88F6281 (Kirkwood based)
* DB-78100 (Discovery based)
For more detailed info on build instructions and other examples please refer
to http://wiki.freebsd.org/FreeBSDMarvell
Obtained from: Marvell, Semihalf
user-mode pointers. Change types used in the structures definitions to
properly-sized architecture-specific types.
Submitted by: dchagin
MFC after: 1 week
This supports 1Gbps Ethernet engine found on ARM-based SOCs (Orion, Kirkwood,
Discovery), as well as on system controllers for PowerPC processors (MV64430,
MV6446x).
The following advanced features are supported:
- multicast
- VLAN tagging
- IP/TCP/UDP checksum calculation offloading
- polling
- interrupt coalescing
Obtained from: Marvell, Semihalf
Vendor import of tzdata2008h
- Minor update for Mauritius (which I don't understand)
- Syria goes to DST at 1 November instead of 1 October.
- Niue is now located at the right side of the equator.
- Minor update for Mauritius (which I don't understand)
- Syria goes to DST at 1 November instead of 1 October.
- Niue is now located at the right side of the equator.
freaks me out. But it turns out we might be able to generalize
a few of the other things RE uses to assemble the package trees
for releases if the DVDs use a naming theme close to what is used
for the CDROMS (disc1, disc2, etc). So change the name to dvd1.
Hopefully this way src/release/scripts/{package-split.py,package-trees.sh}
can be generalized instead of copied-and-hacked.
MFC after: 5 days
the last byte of the ethernet address was not read which in turn
resulted in getting 5 out of the 6 bytes of ethernet address and
always returned ENOENT. I did not notice the bug on FPGA version
because of additional configuration data in EEPROM.
Pointed out by: bouyer at NetBSD
example the Huawei Mobile has an SD card slot on the second interface.
- Do not attach to Qualcomm and Novatel cards. If ignored these cards will
switch to modem mode automatically it seems.
- Reduce the priority on generic attachment to the appropriate level.
Note: A better solution is to send an eject command straightaway, but that can
be left till later.
derivitive of NetBSD's mips_reloc.c, so pull in the copyright notice
from there.
Also, a minor tweak to load/store pointers. Other changes from NetBSD
likely would be useful too...
Obtained from: NetBSD
* Orion
- 88F5181
- 88F5182
- 88F5281
* Kirkwood
- 88F6281
* Discovery
- MV78100
The above families of SOCs are built around CPU cores compliant with ARMv5TE
instruction set architecture definition. They share a number of integrated
peripherals. This commit brings support for the following basic elements:
* GPIO
* Interrupt controller
* L1, L2 cache
* Timers, watchdog, RTC
* TWSI (I2C)
* UART
Other peripherals drivers will be introduced separately.
Reviewed by: imp, marcel, stass (Thanks guys!)
Obtained from: Marvell, Semihalf
The physical page which we clear is accessed via additional temp kernel
mapping for the period of zeroing operation. However in systems with virtual
d-cache (most ARMs) when write-allocate feature is enabled, we can have
modified but unflushed content pertaining to this physical page still in the
d-cache due to its primary (pre-existing) mapping. In such scenario that
cached content upon flush is likely to overwrite [portions of] the physical
page we want to zero here..
This is a general problem with multiple virtual mappings covering the same
physical page with write-allocate and virtual d-cache: there is inherent
potential for corruptions of this kind, which are not easily resolved; it is
best policy that such multiple mappings be not allowed.
Obtained from: Marvell, Semihalf
will ease the identification of memory leaks as the OS will be able to track
allocations for us by malloc type. vmstat -m will show all of the
allocations.
Convert the calls to drm_alloc() and friends, which are used in shared code
to static __inline__ while we are here.
Approved by: jhb (mentor)
from operating on a list with a single item. This code is used much more by
the i915 driver with xorg-7.4. Correct it to match the actual linux
implementation.
Approved by: jhb (mentor)
busmastering support. This also adds register definitions for MSI support,
which we will be using shortly.
Approved by: jhb (mentor)
Obtained from: drm git master
