Ruslan Ermilov
c88f165bd5
Uncomment an upcoming 5.4-RELEASE.
2004-12-18 07:20:33 +00:00
Max Laier
905c6b87b7
Make ip_nat compile again. Should read #if->n<-def LARGE_NAT as in ipf 4.x
2004-12-18 03:47:54 +00:00
Julian Elischer
53d4f8518a
Slight change to formatting so that 'ctags' doesn't
...
give up on teh file half way through.. Might have been my
mistake earlier anyhow. No actual code change
MFC after: 5 days
2004-12-18 01:20:18 +00:00
Joseph Koshy
26f67c9cae
Document "machdep.hlt_cpus".
...
Reviewed by: ru
2004-12-18 01:13:37 +00:00
Joseph Koshy
41ecd18235
Uncomment entries for FreeBSD 6.0 and 4.11.
...
Requested by: ru
2004-12-18 01:07:18 +00:00
Christian Brueffer
4b2c187db5
Specify the state of my birth, similar to other entries.
2004-12-18 00:58:22 +00:00
Christian Brueffer
9c629c3588
BCM5721 is supported as well.
2004-12-17 23:03:30 +00:00
Paul Saab
35ca8069a9
Add support for the 5721 which seems to be similar to the 5750/5751.
...
Tested by: Vivek Khera vivek at khera dot org
2004-12-17 21:50:18 +00:00
Ralf S. Engelschall
8747427026
1. To give the user a clue about the expiration timeout values, mention
...
the default timeouts of 1800 (activity) and 15 (inactivity) seconds.
2. Fix the "ifinfo" ASCII control message description:
it requires the interface number as an argument.
MFC after: 2 days
2004-12-17 20:49:01 +00:00
Matthew N. Dodd
86906d256a
Diff reduce wi_write_wep() relative to revision 1.168
2004-12-17 20:48:13 +00:00
Christian Brueffer
fa3f865d01
Modify the name of the supported bluetooth card.
...
Discussed with: emax
2004-12-17 19:01:55 +00:00
Alan Cox
98fe9a0ddf
Eliminate another unnecessary call to vm_page_busy(). (See revision 1.333
...
for a detailed explanation.)
2004-12-17 18:54:51 +00:00
Christian Brueffer
d94b44fb9c
Autogenerate device listings for umass(4).
...
MFC after: 3 days
2004-12-17 18:37:58 +00:00
Christian Brueffer
703fdea062
- add a HARDWARE section based on the hardware notes and the devices
...
already listed in the manpage
- reword some DESCRIPTION sentences
- Xref ehci(4)
- bump .Dd
MFC after: 3 days
2004-12-17 18:35:38 +00:00
Simon L. B. Nielsen
c70d1f767c
Correct entity name added in the last revision.
2004-12-17 18:19:44 +00:00
Peter Wemm
d6ef0bf119
Recognize the 32-bit form of the twe binary passthrough ioctl()s so that
...
there is some hope for the 32-bit management utilities to run. I've used
the cli successfully, but 3dm2 doesn't work for other reasons. Of course,
a native binary of the 3dm2 and cli would be much better, but that doesn't
exist.
2004-12-17 17:45:29 +00:00
Alan Cox
06c98c5dcc
Enable debug.mpsafevm by default on alpha.
2004-12-17 17:17:36 +00:00
Joseph Koshy
548c9b4376
Revert rev 1.66. This file needs to track its upstream source.
...
Requested by: ru
2004-12-17 16:29:54 +00:00
Darren Reed
f42b5dbebb
Move two variables that are unused if LARGE_NAT is defined inside an #ifdef
...
to keep them out of harms way when compiling.
PR: 72783
2004-12-17 15:59:16 +00:00
Joseph Koshy
f33e5b1ab2
Mark mknod(8) as deprecated. Add text in the 'COMPATIBILITY' section
...
describing the changes in device management since FreeBSD 4.0.
Reviewed by: ru
2004-12-17 14:36:02 +00:00
Joseph Koshy
7b01553c1d
Remove mention of block devices. Mention that entries under /dev
...
are managed by devfs(5). Add cross-references.
Reviewed by: ru
2004-12-17 14:28:53 +00:00
Joseph Koshy
e791235b73
Support for ".Fx 6.0".
...
Reviewed by: ru
2004-12-17 14:10:44 +00:00
Kirill Ponomarev
e57fe04667
Introduce new variables FETCHINDEX, MASTER_SITE_INDEX and add
...
description for MASTER_SITE_BACKUP.
Based on PR: ports/74709
Submitted by: Valentin Nechayev <netch@netch.kiev.ua>
Reviewed by: ru
MFC after: 3 days
2004-12-17 13:39:55 +00:00
Ruslan Ermilov
0207facc8f
err() -> errx()
2004-12-17 13:24:22 +00:00
Hartmut Brandt
674a77f864
Remove all the cleanup functions. There is no reason to free memory
...
just before exiting (especially given the number of memory leaks) -
it just costs time.
2004-12-17 13:20:19 +00:00
Gleb Smirnoff
db8d970ac4
Bump .Dd
...
Reminded by: ru
2004-12-17 12:59:20 +00:00
Gleb Smirnoff
85432d4065
Note that send(2) is no longer applicable to divert(4) sockets.
...
Noticed by: Dmitry Dvoinikov
Wording by: cperciva
MFC after: 3 days
2004-12-17 11:24:33 +00:00
Christian Brueffer
d6fc8c994a
Autogenerate device listings for ng_bt3c(4).
...
MFC after: 3 days
2004-12-17 10:31:00 +00:00
Christian Brueffer
a125287a47
- add a HARDWARE section
...
- several grammar and language fixes
- bump .Dd
MFC after: 3 days
2004-12-17 10:13:02 +00:00
Ruslan Ermilov
3a35b5b9a5
Minor tweaks in "make update" comments.
2004-12-17 10:11:33 +00:00
Christian Brueffer
34676354ec
Add missing word.
...
MFC after: 3 days
2004-12-17 09:34:48 +00:00
Sam Leffler
181ab45653
Fix wep operation for station mode:
...
o don't encapsulate on tx; the chip expect a raw frame w/o the crypto header
o clear the WEP bit in the 802.11 header on rx so the 802.11 layer doesn't
try to strip the crypto header
o clobber the "drop unencoded frames" state bit when privacy is enabled so
rx'd frames we pass up to the 802.11 layer are not discarded as unencrypted
This stuff will need to be redone if anyone decides to add WPA support.
2004-12-17 03:57:16 +00:00
Sam Leffler
14ae1a9deb
set ic_ibss_chan when entering RUN state to match ic_bss so the channel
...
reported when associated to an AP is correct
2004-12-17 03:36:24 +00:00
John-Mark Gurney
86c9a45388
don't try to recurse on the bpf lock.. kqueue already locks the bpf lock
...
now...
Submitted by: Ed Maste of Sandvine Inc.
MFC after: 1 week
2004-12-17 03:21:46 +00:00
Sam Leffler
407a27b151
remove power save logic from the tx path; the driver isn't ready to support
...
it so don't mislead folks
2004-12-17 03:05:30 +00:00
Christian Brueffer
8925c08f8d
Properly capitalize FireWire
...
MFC after: 3 days
2004-12-17 02:33:42 +00:00
Darren Reed
8a377db272
Allow ipnat redirect rules to work for non-TCP/UDP packets.
...
PR: 70038
Submitted by: fming@borderware.com
Reviewed by: darrenr
Obtained from: fming@borderware.com
2004-12-17 02:29:34 +00:00
Garance A Drosehn
bea5945e6f
When printing a data file received from some other host, check to make
...
sure the data file has been completely transfered before starting to
print it. This is needed because some implementations of lpr will send
the control-file for a print job before sending the matching data-files,
and that can cause problems if the receiving host is a busy print-server.
MFC after: 2 weeks
2004-12-17 01:54:50 +00:00
Julian Elischer
993a0480b7
Forced commit to note that the previous patch apparently
...
came originaly from the keyboard of:
Submitted by: Branko Lankester <branko@euro.net>
2004-12-17 00:57:48 +00:00
Julian Elischer
5f15e3ac21
Add a missing prototype.
...
MFC after: 1 week
2004-12-17 00:25:56 +00:00
Julian Elischer
080bb7c1dd
Allow /sys/dev/bktr to support Pinnacle PCTV Rave cards
...
PR: 73669
Submitted by: arne_woerner at yahoo dot com
MFC after: 1 week
2004-12-16 23:37:41 +00:00
Julian Elischer
b7ad4d221a
Add some locking for -currnet/5.x
...
PR: 74305
Submitted by: Anish Mistry <amistry at am-productions dot biz>
MFC after: 1 week
2004-12-16 23:19:57 +00:00
Nate Lawson
af952b363b
Inform users how to set throttling and cpu idling variables for the
...
power_profile rc script.
2004-12-16 22:21:21 +00:00
Darren Reed
6de0f6c8b8
Using just m_pullup to get all of the interesting bits in packet into one
...
buffer doesn't work for ipv6 packets, so use m_defrag() here instead as an
easy drop-in replacement.
PR: 70399
2004-12-16 21:02:16 +00:00
David Schultz
527055d12f
GC unused declaration
2004-12-16 20:40:49 +00:00
David Schultz
17519e9b79
Cosmetic changes only:
...
- style
- remove unused variables
- de-support VAX
Inspired by: bin/42388
2004-12-16 20:40:37 +00:00
Maxim Konovalov
63173f5f56
o The macro versions of sigemptyset(3), sigfillset(3), sigaddset(3),
...
sigdelset(3) and sigismember(3) were killed about five years ago.
o The functions (specifically sigismember(3)) could return -1 and
set errno.
PR: bin/75156
Obtained from: NetBSD
MFC after: 2 weeks
o Bump the date of the document.
2004-12-16 20:27:55 +00:00
Ruslan Ermilov
e9bddef1f0
Previous revision didn't fix all cases. For example,
...
testing for variables that are always defined (e.g.,
"make -V CC") would still print a false warning. Fix
this by only passing a submake the MAKEOBJDIRPREFIX=*
argument if it was present. As a result, we loose
the check for -DMAKEOBJDIRPREFIX, or an esoteric
"MAKEOBJDIRPREFIX = foo" (with embedded spaces), but
these are unorthodox enough to not care about them.
The make(1) bug mentioned in the previous revision
was just fixed in make/main.c,v 1.109.
2004-12-16 19:55:57 +00:00
Ruslan Ermilov
025bfb24c4
Fix a long-standing bug when make(1) is passed the -V and
...
-f options in MAKEFLAGS environment variable, and some of
these options are also specified on the command line.
Thanks to: marcel
Reviewed by: harti
2004-12-16 19:46:50 +00:00
Paul Saab
cb36cd34b8
Change the NFS sillyrename convention so that we won't run out
...
of sillyrenames (which were limited to 58 per pid per directory,
for no good reason). The new format of sillyrenames looks like
.nfs.0000b31a.00d24.4
^^^^^^^^ ^^^^^
ticks pid
Submitted by: Mohan Srinivasan mohans at yahoo-inc dot com
Obtained from: Yahoo!
2004-12-16 19:28:37 +00:00