make the sequencer code fully compatible with the aic7870 (ie 294x adaptors).
I've also added to my local mods putting the sequencer into "FASTMODE" clock.
This gives upwards of 2M/sec write preformance improvement in some scenarios.
There haven't been any reports of this causing problems, and I have been
reaping the benifits of it for more than a week now.
This also includes a new version of the pre-generated file <ugh>
Obtained from: John Aycock (aycock@cpsc.ucalgary.ca) and myself
a discussion going on about removing this code from the burden of the
GPL, but it won't happen before Beta, and this code should be tested
before release.
Supports 27/2842 class adaptec cards and is almost capable of supporting
aic7870 based adapters (294X series cards). It does not support Wide
controllers or the second channel on Twin boards although I have work in
progress on getting both channels and running.
I have also added a few performance improvements to this version that give
us approximately a 25% boost over the original driver. These patches have
been submitted to the author.
Obtained from: Linux aic7770 driver (John Aycock - aycock@cpsc.ucalgary.ca)
put_fs_word() to fuword() and suword(). Linux words are 16 bits
but BSD words are 32-bits, at least on vax's. Writing a too-large
word trashed the neighbouring short word.
Bruce
from David Greenman, Bruce Evans and Julian Elischer.
They are:
[vnode pager - David/Bruce]:
The following patch fixes a problem where some data could be lost in a
delayed-write buffer if the cached buffer was larger than a page. This fix was
provided by Bruce Evans and modified slightly by me.
[st.c - Julian]:
My fix for "bad request, must be between 0 and 0"
RTFS if you're interested).
[gnu/fpemul - David/Bruce]:
These changes fix single stepping of emulated FPU instructions.
Previously, the instruction after an emulated instruction was
executed without causing a SIGTRAP ...
The also fix the initial control word being different for the
GPL emulator (it is still wrong for the old emulator) and remove
an unnecessary panic when emulation is not configured (I hope at
least init, sh and reboot will run without floating point. I
remember only df and mkfs being broken by the lack of FP in 0.0).
[Various fixes described below - Bruce/David]:
sys/i386/boot/boot2.S:
Yet another attempt to propagate the correct fix for 16 vs
32-bit mode bugs. [verified]
sys/i386/i386/db_interface.c:
Protect against reentering Debugger().
sys/kern/kern_time.c:
Don't allow 'time.tv_usec == 0' except at clock interrupts.
sys/pcfs/pcfs_fat.c:
Make it compile without -O.
sys/scsi/sd.c:
Fix as posted to some freebsd mailing list.
(changes the order of the assignment of "sectors" because it earlier
value is needed first -DG)
sys/vm/vm_glue.c:
Fix stale comments and verbose code.
sys/vm/vm_mmap.c
Fix off by 1 errors and verbose code.
[From Nate - cosmetic but non-intrusive and useful enough to go in]
sys/i386/isa/isa.c:
Appended you'll find a patch to the NMI error log routine in isa/isa.c.
The below patch just adds some additional information when an NMI occurs
which can help debug the hardware problem.
Justin T. Gibbs
Jordan K. Hubbard
Poul-Henning Kamp
David Greenman
Bruce Evans
Paul Richards
Rich Murphey
Rodney W. Grimes
Gary Clark II