works from startup, and works with XFree86 via /dev/sysmouse, it should
be started at boot and left running.
Pointed out by: Sujal Patel <smpatel@umiacs.umd.edu>
I could find. This change does the following:
- s/usage()/break;/ in handling the -s switch.
- use err/warn instead of fprintf(stderr, ... strerror()); exit(1);
- implement Hitachi PUMA HitTablet support from the XFree86 code,
whatever the hell that is. :-)
- correctly implement baud rate setting, too much was cut from the
XFree86 code, the critical parts were a sweep over all likely
mouse powerup baud rates to switch it to the reqested rate.
- logitech support was busted (at least on mine, which is autosensing
and runs in either mmseries or logitech mode depending on the handshake
code at startup. Among other things, you talk to it at 1200, then
switch to the target baud later.
Some remaining problems.. samplerate setting is missing, but I've not
found where this is meant to be set yet. I presume this is resolution
setting of some kind.
via an ioctl (MOUSE_ACTION).
Fixed a couple of bugs (destructive cursor, uncut, jitter).
Now applications can use the mouse via the MOUSE_MODE ioctl, its
possible to have a signal sent on mouseevents, makeing an event loop
in the application take over mouseevents.
functionality in syscons and the real mouse hardware. If moused is
run one can switch on/off the mousepointer with vidcontrol -m on/off.
There is no manpage yet, but a fairly descriptive usage message....
Reviewed by:sos
Submitted by: Michael Smith
Obtained from:Some of the mouselogic comes from XFree86
Mike Pritchard
Peter Wemm
Søren Schmidt