necessary to call it when the tty layer's output state has not been
changed, but siostop() sometimes changes the TS_BUSY state and then
calls comstart() mainly for its side effect of calling ttwwakeup().
need to do it directly, since ttwwakeup() is always called just before
returning from rpstart(). The brokenness was waking up the wrong address
after clearing TS_SO_OLOWAT. It's not clear how processes waiting for
output to drain below low water ever got woken up.
Found by: when I fixed longstanding warts in output watermark
handling, this was the only driver that knew too much
(anything) about the watermarks
for field widths being 2 larger than specified for "%<number>p". Only
printing of null pointers is "wrong" now (it is actually "right", but
inconsistent with printf(3)).
When CCP is originally negotiated, the only thing we can be
sure about is that we've started adding data to the inflate
dictionary either before or at the same time as the peer. This
is ok, 'cos DEFLATE is a `sliding window' compressor.
really used any features from <sys/malloc.h> since it was "blasted
from the past" in rev.1.15, and most .c files did not depend on
the namespace pollution (others have been fixed). The mbuf allocation
control values M_DONTWAIT and M_WAIT were just defined in terms of
the malloc control values M_NOWAIT and M_WAITOK. The mbuf values
are now defined directly.
here, but kmem_malloc() is used and it takes the same "flags" as
malloc().
Use the mbuf allocation "flags" M_WAIT and M_DONTWAIT consistently.
There is really only one boolean flag, M_DONTWAIT, but the "flags"
were always treated as enum-like values, except in some places here
where the values are tacitly converted to boolean flags. Treat
them as enum-like values everywhere, except where we tacitly assume
that there are only two values in order to convert them to the
corresponding two kmem_malloc() "flags".
Show the IP range (if specified) in "show ipcp".
Close unused descriptors 0 and 2 in interactive mode.
Pass (size_t *) rather than (int *) to sysctl().
Don't read(fd, buffer, 0) and think ppp has closed the
connection when `buffer' is full, instead, flush most of
buffer to the terminal and read() for a reasonable length.
This fixes "show route" when there's more than 2k of
routing output.
used, and caused a reference to an uninitialised variable (state).
I think I've fixed it now, but since nothing in the tree seems to use it,
I'm not sure.
under -current. The actual preparation of the next track will now be
deferred until just before the first write operation. Otherwise,
opening the device with write intent will cause the execution of
commands that are illegal in `limited command set mode' (i.e., after
the write channel has been opened).
While i was at it, cleaned up the worm_open() function a bit.
Removed the volume overflow pre-check in worm_strategy(). It was
time-consuming, and rather useless in many cases anyway (with the size
being reported for just the entire volume only), so we can as well let
the actual SCSI command fail instead, where it'll properly be reported
as EIO.
Partially submitted by & discussed with: jmz
Steve Price
Bruce Evans
Brian Somers
Jordan K. Hubbard
Garrett Wollman
Alexander Langer
Wolfram Schneider
Peter Wemm
Warner Losh
Poul-Henning Kamp
Tim Vanderhoek
Joerg Wunsch
Wolfgang Helbig
John Dyson